Details

---

BUY MCP6022-I/P https://www.utsource.net/itm/p/12380441.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	-	1.8	-	5.5	V
Supply Current (Each Amp)	IDD	VDD = 5V, G = 1	-	1.3	1.7	渭A
Input Bias Current	IB	VDD = 5V, TA = 25掳C	-100	0	100	nA
Input Offset Voltage	VOS	VDD = 5V, TA = 25掳C	-10	0	10	渭V
Common-Mode Input Range	VCM	-	VSS - 0.3	-	VDD + 0.3	V
Output Voltage Swing	VOUT	No Load, VDD = 5V	0.1	-	4.9	V
Slew Rate	SR	VDD = 5V, G = 1	-	0.6	-	V/渭s
Gain Bandwidth Product	GBP	VDD = 5V, G = 1	-	1.2	-	MHz
Unity Gain Frequency	fUG	VDD = 5V, G = 1	-	1.2	-	MHz
Phase Margin	PM	VDD = 5V, G = 1	-	60	-	掳
Operating Temperature	TA	-	-40	-	125	掳C

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (V_DD) is within the range of 1.8V to 5.5V.
   • Connect the power supply to the V_DD and V_SS pins.

2. Input Connections:

   • Connect the input signals to the non-inverting (+) and inverting (-) inputs of each operational amplifier.
   • Ensure the common-mode input voltage (V_CM) stays within the range of V_SS - 0.3V to V_DD + 0.3V.

3. Output Connections:

   • The output voltage swing can range from 0.1V to 4.9V when no load is connected.
   • Connect the output to the desired load or next stage of the circuit.

4. Gain Configuration:

   • Set the gain using external resistors. For unity gain, connect the output directly to the inverting input.
   • For higher gains, use a feedback resistor (R_F) and an input resistor (R_I) with the gain given by G = 1 + R_F/R_I.

5. Temperature Considerations:

   • The device is designed to operate over a temperature range of -40掳C to 125掳C.
   • Ensure the ambient temperature does not exceed these limits to avoid damage or performance degradation.

6. Stability:

   • The phase margin of 60掳 ensures stable operation under most conditions.
   • If stability issues arise, consider adding compensation capacitors or adjusting the gain configuration.

7. Handling:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage.
   • Follow standard ESD precautions when handling and soldering the device.

8. Storage:

   • Store the device in a dry, cool place to prevent moisture damage.
   • Follow recommended storage conditions as specified in the datasheet.

(For reference only)