Details

---

BUY T588N16TOF https://www.utsource.net/itm/p/12381187.html

Parameter	Description	Min	Typ	Max	Unit
VDS	Drain-Source Voltage	-	100	-	V
VGS	Gate-Source Voltage	-10	0	10	V
ID	Continuous Drain Current	-	16	-	A
RDS(on)	On-State Resistance at VGS = 10V	-	2.2	-	Ω
PTOT	Total Power Dissipation	-	30	-	W
TJ	Junction Temperature	-55	-	150	°C
TSTG	Storage Temperature Range	-55	-	150	°C

Instructions for Use:

1. Handling:

   • Handle the T588N16TOF with care to avoid damage to the leads or the body.
   • Use proper ESD (Electrostatic Discharge) precautions to prevent damage from static electricity.

2. Mounting:

   • Ensure that the mounting surface is flat and clean.
   • Apply thermal paste between the device and the heatsink to improve heat dissipation.
   • Tighten the mounting screws to the recommended torque specified in the datasheet.

3. Soldering:

   • Preheat the PCB to reduce thermal shock.
   • Use a soldering iron with a temperature range of 260°C to 300°C.
   • Solder each lead within 3 seconds to avoid overheating.
   • Allow the device to cool naturally after soldering.

4. Operation:

   • Ensure that the V_DS does not exceed 100V to prevent breakdown.
   • Keep the gate-source voltage (V_GS) within the range of -10V to 10V to avoid gate damage.
   • Do not exceed the continuous drain current (I_D) of 16A to prevent overheating.
   • Monitor the junction temperature (T_J) to ensure it remains below 150°C.
   • Use appropriate cooling methods (heatsinks, fans) to manage heat dissipation.

5. Storage:

   • Store the T588N16TOF in a dry, cool place away from direct sunlight.
   • Keep the device in its original packaging until ready for use to protect against moisture and physical damage.

6. Testing:

   • Use a multimeter to check for continuity and resistance values before and after installation.
   • Perform functional tests under controlled conditions to ensure the device is operating correctly.

7. Troubleshooting:

   • If the device fails to operate, check for proper connections and power supply.
   • Verify that the gate-source voltage is within the specified range.
   • Check the heatsink and cooling system for proper operation.
   • Replace the device if it shows signs of physical damage or excessive wear.

(For reference only)