Details

---

BUY NE5517AN https://www.utsource.net/itm/p/12381234.html

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VCC	4.5	-	36	V
Quiescent Current	IQ	-	8	-	mA
Input Voltage Range	VIN	0	-	VCC - 1.5	V
Differential Input Voltage	VDIF	卤25	-	-	V
Output Voltage Swing	VOUT	0	-	VCC - 1.5	V
Slew Rate	SR	-	10	-	V/渭s
Bandwidth (0.1% Distortion)	fBW	-	10	-	MHz
Gain Bandwidth Product	GBP	-	100	-	MHz
Large Signal Voltage Gain	AV	-	1000	-	V/V
Input Bias Current	IB	-	100	-	nA
Input Offset Current	IOS	-	20	-	nA
Input Offset Voltage	VOS	-	5	-	mV
Common Mode Rejection Ratio	CMRR	-	90	-	dB
Power Supply Rejection Ratio	PSRR	-	80	-	dB
Operating Temperature Range	TA	-40	-	85	掳C

Instructions for Use:

1. Power Supply:

   • The NE5517AN can operate with a supply voltage ranging from 4.5V to 36V.
   • Ensure that the power supply is stable and free from noise to avoid performance degradation.

2. Input Signals:

   • The input voltage range should be between 0V and V_CC - 1.5V.
   • The differential input voltage can be up to 卤25V without damaging the device.

3. Output Configuration:

   • The output voltage swing is from 0V to V_CC - 1.5V.
   • For optimal performance, ensure that the load resistance is appropriate for the output current capabilities.

4. Biasing:

   • The input bias current is typically 100nA, and the input offset current is 20nA.
   • Use high-quality input resistors to minimize the impact of these currents on the circuit.

5. Offset Voltage:

   • The input offset voltage is typically 5mV. Use trimming techniques if precise offset control is required.

6. Stability:

   • The NE5517AN has a gain bandwidth product of 100MHz and a slew rate of 10V/渭s.
   • Ensure that the feedback network is properly designed to maintain stability at high frequencies.

7. Temperature Considerations:

   • The operating temperature range is from -40掳C to 85掳C.
   • Ensure adequate heat dissipation if the device is operated near the upper temperature limit.

8. Protection:

   • The device includes internal protection circuits to prevent damage from overvoltage and short circuits.
   • However, it is recommended to use external protection components for robust designs.

9. Layout:

   • Use a good ground plane and keep signal traces as short as possible to minimize noise and interference.
   • Place bypass capacitors close to the power pins to ensure stable operation.

10. Storage:

    • Store the device in a dry, cool place to prevent moisture damage.
    • Handle with care to avoid static discharge, which can damage the sensitive components.

(For reference only)