Details

---

BUY LM324PWRG4 https://www.utsource.net/itm/p/12383099.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating Range	3	-	32	V
Input Offset Voltage	VIO	VCC = 卤15V	-5	2	7	mV
Input Bias Current	IB	VCC = 卤15V	20	80	500	nA
Input Offset Current	IOS	VCC = 卤15V	-10	5	70	nA
Differential Input Voltage Range	VID	VCC = 卤15V	-30	-	30	V
Output Short-Circuit Protection	-	Continuous	-	Yes	-	-
Output Voltage Swing	VOUT	No Load, VCC = 15V	0	-	14	V
Quiescent Current	IQ	Per Amplifier	0.4	0.8	1.0	mA
Slew Rate	SR	VCC = 卤15V	0.5	-	-	V/渭s
Common-Mode Rejection Ratio	CMRR	VCC = 卤15V	70	-	-	dB
Power Dissipation	PD	Maximum	-	-	620	mW
Operating Temperature Range	TA	Commercial Grade	0	-	70	掳C
Storage Temperature Range	TSTG		-65	-	150	掳C

Instructions for Use:

1. Power Supply:

   • The LM324PWRG4 can operate from a single supply (3V to 32V) or dual supplies (卤1.5V to 卤16V).
   • Ensure the power supply is stable and within the specified range to avoid damage.

2. Input Signals:

   • The input signals should be within the common-mode input voltage range.
   • Avoid exceeding the differential input voltage range to prevent damage.

3. Output Configuration:

   • The output can swing close to the supply rails but may not reach them exactly.
   • For optimal performance, use a load resistor to ground or a pull-up resistor if driving a high-impedance load.

4. Biasing and Offset:

   • The input bias current and offset current are relatively low but should be considered when designing circuits with high impedance sources.
   • Use compensation capacitors if necessary to stabilize the circuit.

5. Thermal Management:

   • Ensure adequate heat dissipation, especially at higher power levels.
   • Do not exceed the maximum power dissipation rating.

6. Storage and Handling:

   • Store the device in a dry environment to prevent moisture damage.
   • Handle with care to avoid static discharge, which can damage the internal components.

7. Testing and Troubleshooting:

   • Before testing, ensure all connections are correct and secure.
   • Use a multimeter to check for short circuits and open circuits.
   • If the device does not function as expected, check the power supply, input signals, and output loads.

(For reference only)