Details
BUY ST62T65CM6 https://www.utsource.net/itm/p/12402863.html
Parameter | Description | Value | Unit |
---|---|---|---|
Part Number | Single-chip microcontroller with EEPROM | ST62T65CM6 | - |
Package | Type of package | TSSOP20 | - |
Operating Voltage | Supply voltage range | 2.0 to 5.5 | V |
Operating Temperature | Temperature range for operation | -40 to +85 | °C |
Flash Memory | Size of flash memory | 8 | KB |
EEPROM | Size of EEPROM | 128 | bytes |
RAM | Size of RAM | 384 | bytes |
Clock Speed | Maximum clock frequency | 24 | MHz |
I/O Pins | Number of I/O pins | 16 | - |
ADC Channels | Number of analog-to-digital converter channels | 8 | - |
Timer(s) | Number and type of timers | 2 x 16-bit | - |
Communication Interfaces | Supported communication interfaces | UART, SPI, I2C | - |
Watchdog Timer | Availability of watchdog timer | Yes | - |
Low Power Mode | Types of low power modes supported | Sleep, Stop | - |
Instructions for Use:
Power Supply: Ensure the supply voltage is within the operating voltage range (2.0V to 5.5V). Connect VDD to the positive supply and VSS to ground.
Clock Configuration: The device supports both internal and external clock sources. For external crystal or oscillator, connect it to the OSC1 and OSC2 pins as specified in the datasheet.
Programmer Interface: Use an appropriate programmer that supports the ST62T65CM6 for uploading code. Ensure correct settings for the interface (e.g., ISP, IAP).
Pin Configuration: Configure the I/O pins based on your application needs. Refer to the pin diagram in the datasheet for specific functions.
Communication Setup: Initialize the UART, SPI, or I2C interfaces according to the protocol specifications provided in the datasheet.
ADC Operation: To use the ADC, configure the ADC channels and start conversions using the software commands provided in the programming manual.
Timers and Interrupts: Set up the timers and enable interrupts if required. Program the interrupt service routines (ISRs) to handle events.
Low Power Modes: Enter sleep or stop modes by configuring the respective control registers. Ensure proper wake-up conditions are set.
Watchdog Timer: Enable the watchdog timer to prevent system lockups. Configure the timeout period as needed.
EEPROM Operations: Use the EEPROM for non-volatile data storage. Write operations should be handled carefully to avoid excessive wear.
For detailed setup and advanced configurations, refer to the official ST62T65CM6 datasheet and application notes.
(For reference only)View more about ST62T65CM6 on main site