Details

---

BUY MC33072PG https://www.utsource.net/itm/p/12404320.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	VCC	2.0	5.0	36.0	V	Operating supply voltage range
Input Voltage Range	VI	0	-	VCC	V	Range of input voltages for the operational amplifiers
Output Voltage Swing (No Load)	VOL	0.01	-	VCC - 0.01	V	Output voltage swing from rail to rail
Quiescent Current per Amplifier	IQ	-	1.8	-	mA	Current consumed by each amplifier at quiescent state
Input Bias Current	IB	-	20	-	nA	Average current flowing into the input terminals
Input Offset Current	IOS	-	5	-	nA	Difference in bias currents between the two inputs
Input Offset Voltage	VOS	-	2	-	mV	Voltage difference between the two inputs when the output is zero
Common-Mode Rejection Ratio	CMRR	-	90	-	dB	Measure of the ability to reject common-mode signals
Power Supply Rejection Ratio	PSRR	-	90	-	dB	Measure of the ability to reject power supply variations
Slew Rate	SR	-	0.3	-	V/渭s	Rate of change of output voltage per unit time
Bandwidth (Unity Gain)	fT	-	1.1	-	MHz	Frequency at which the gain of the amplifier drops to unity
Operating Temperature Range	TA	-40	-	125	掳C	Ambient temperature range for operation

Instructions for Using the MC33072PG

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the specified range of 2.0V to 36.0V.
   • Connect the V_CC pin to the positive supply and the GND pin to the ground.

2. Input Signals:

   • The input signals should be within the range of 0V to V_CC.
   • Avoid applying voltages outside this range to prevent damage to the device.

3. Output Configuration:

   • The output can swing very close to the supply rails, but ensure there is a small margin (0.01V) to avoid distortion.
   • Use appropriate load resistors to match the output impedance requirements.

4. Biasing and Offset:

   • The input bias current is typically 20nA, so use high-impedance sources to minimize errors.
   • The input offset voltage and current should be considered when designing precision circuits.

5. Common-Mode and Power Supply Rejection:

   • The device has good common-mode rejection (CMRR) and power supply rejection (PSRR), making it suitable for noisy environments.
   • Use bypass capacitors (e.g., 0.1渭F) near the power pins to filter out noise.

6. Slew Rate and Bandwidth:

   • The slew rate is 0.3V/渭s, which limits the maximum rate of change of the output voltage.
   • The unity gain bandwidth is 1.1MHz, which determines the highest frequency at which the amplifier can operate effectively.

7. Temperature Considerations:

   • The device is rated for operation from -40掳C to 125掳C. Ensure proper thermal management to maintain performance within this range.

8. Handling and Storage:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage.
   • Store in a dry, cool place away from direct sunlight and corrosive substances.

(For reference only)