Details

---

BUY MC33202P https://www.utsource.net/itm/p/12426948.html

Parameter	Symbol	Min	Typ	Max	Unit	Notes
Supply Voltage	VCC	2.7	-	5.5	V
Input Offset Voltage	VIO	-15	0	15	渭V
Input Bias Current	IB	-	10	50	nA
Input Voltage Range	VI	0	-	VCC - 1.5	V
Output Voltage Swing	VOS	0	-	VCC - 1.5	V
Slew Rate	SR	-	0.5	-	V/渭s
Quiescent Current	IQ	-	400	-	渭A
Common-Mode Rejection Ratio	CMRR	-	85	-	dB	@ 1 kHz
Power Supply Rejection Ratio	PSRR	-	100	-	dB	@ 1 kHz
Bandwidth	BW	-	1.2	-	MHz
Operating Temperature Range	TA	-40	-	125	掳C

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the range of 2.7V to 5.5V.
   • Connect a bypass capacitor (typically 0.1 渭F) between V_CC and GND close to the IC to filter out noise.

2. Input Signals:

   • The input voltage range should be from 0V to V_CC - 1.5V.
   • Avoid exceeding the input voltage limits to prevent damage to the IC.

3. Output Configuration:

   • The output voltage swing is from 0V to V_CC - 1.5V.
   • Use appropriate load resistors to ensure the output current does not exceed the maximum rating.

4. Thermal Considerations:

   • The operating temperature range is from -40掳C to 125掳C.
   • Ensure adequate heat dissipation if the IC is used in high-temperature environments.

5. Stability:

   • The MC33202P is internally compensated for stability under most conditions.
   • For applications requiring higher gain or faster response, external compensation may be necessary.

6. Common-Mode Rejection Ratio (CMRR):

   • The CMRR is 85 dB at 1 kHz, indicating good rejection of common-mode signals.

7. Power Supply Rejection Ratio (PSRR):

   • The PSRR is 100 dB at 1 kHz, ensuring minimal impact from power supply variations on the output.

8. Bandwidth:

   • The typical bandwidth is 1.2 MHz, suitable for a wide range of analog applications.

9. Quiescent Current:

   • The quiescent current is typically 400 渭A, making the MC33202P suitable for low-power applications.

10. Handling:

    • Handle the IC with care to avoid static damage.
    • Follow standard ESD precautions when handling and soldering the IC.

For detailed specifications and application notes, refer to the official datasheet provided by the manufacturer.

(For reference only)