Details

---

BUY TL084C https://www.utsource.net/itm/p/12442849.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	卤15V	-	卤15	卤18	V
Supply Current	ICC	All amplifiers operating	-	2.3	3.6	mA
Input Offset Voltage	VIO	VI = 0V	-	4	10	mV
Input Bias Current	IB	VI = 0V	-	70	150	nA
Input Offset Current	IOS	VI = 0V	-	10	40	nA
Input Voltage Range	VIN	VCC = 卤15V	-13	-	+13	V
Output Voltage Swing	VOUT	VCC = 卤15V	-12	-	+12	V
Slew Rate	SR	VOUT = 0 to 10V	13	-	-	V/渭s
Bandwidth (Unity Gain)	fT	VCC = 卤15V	-	3	-	MHz
Large Signal Voltage Gain	AV	VCC = 卤15V	40	-	100	dB

Instructions for Use:

1. Power Supply:

   • The TL084C can operate with a supply voltage range of 卤15V to 卤18V.
   • Ensure that the power supply is stable and within the specified range to avoid damage to the device.

2. Input Signals:

   • The input voltage range should be between -13V and +13V when operating at 卤15V supply.
   • Avoid applying voltages outside this range to prevent distortion or damage.

3. Output Signals:

   • The output voltage swing is typically 卤12V when operating at 卤15V supply.
   • Ensure that the load resistance is appropriate to avoid overloading the output stage.

4. Slew Rate:

   • The slew rate is 13 V/渭s, which limits the maximum rate of change of the output voltage.
   • This is important for high-frequency applications to avoid distortion.

5. Gain and Bandwidth:

   • The unity gain bandwidth is typically 3 MHz.
   • The large signal voltage gain is between 40 dB and 100 dB, depending on the application.

6. Biasing and Offset:

   • The input bias current and input offset current are relatively low, but they should be considered in precision applications.
   • Use compensation techniques if necessary to minimize the effects of these parameters.

7. Thermal Considerations:

   • Ensure adequate heat dissipation, especially in high-power applications.
   • Refer to the datasheet for thermal resistance values and recommended PCB layout guidelines.

8. Stability:

   • The TL084C is internally compensated for unity gain stability.
   • However, external compensation may be required for specific applications to ensure stability.

9. Handling:

   • Handle the device with care to avoid static damage.
   • Follow ESD (Electrostatic Discharge) precautions during handling and installation.

10. Storage:

    • Store the device in a dry, cool environment to prevent moisture damage.
    • Keep the device in its original packaging until ready for use.

(For reference only)