Details

---

BUY MAX3001EEUP+ https://www.utsource.net/itm/p/12442856.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	Operating	2.7	-	5.5	V
Supply Current	IDD	Quiescent	-	10	-	μA
Input Voltage Range	VIN	Differential	-0.3	-	VDD + 0.3	V
Common-Mode Rejection Ratio	CMRR	-	-	86	-	dB
Power-Down Mode Current	IPD	-	-	0.5	-	μA
Output Voltage Swing	VOUT	Load = 10 kΩ	0.01	-	VDD - 0.01	V
Bandwidth	fBW	-3 dB	-	100	-	kHz
Slew Rate	SR	-	-	1.5	-	V/μs
Input Bias Current	IB	-	-	1	-	nA
Input Offset Voltage	VOS	-	-	50	-	μV

Instructions for Using the MAX3001EEUP+

1. Power Supply:

   • Connect the V_DD pin to a power supply within the range of 2.7V to 5.5V.
   • Connect the GND pin to the ground.

2. Input Signals:

   • Apply differential input signals to the IN+ and IN- pins. Ensure the input voltage range is between -0.3V and V_DD + 0.3V to avoid damage.

3. Output Configuration:

   • The output voltage swing is from 0.01V to V_DD - 0.01V. Connect a load resistor (e.g., 10 kΩ) to ensure proper operation.

4. Power-Down Mode:

   • To reduce power consumption, set the device into power-down mode by pulling the SHDN pin low. The current consumption in this mode is typically 0.5 μA.

5. Common-Mode Rejection:

   • The device has a high common-mode rejection ratio (CMRR) of 86 dB, making it suitable for applications where common-mode noise is a concern.

6. Slew Rate and Bandwidth:

   • The slew rate is 1.5 V/μs, and the bandwidth is 100 kHz at -3 dB. These parameters should be considered when designing the circuit to ensure stability and performance.

7. Bias Current and Offset Voltage:

   • The input bias current is 1 nA, and the input offset voltage is 50 μV. These values are important for precision applications.

8. Layout Considerations:

   • Use short traces for input and output signals to minimize parasitic capacitance and inductance.
   • Place decoupling capacitors close to the V_DD and GND pins to filter out noise and provide stable power supply.

9. Handling:

   • Handle the device with care to avoid static discharge, which can damage the sensitive internal components.
   • Follow proper ESD (Electrostatic Discharge) precautions during handling and installation.

By following these instructions, you can ensure optimal performance and reliability of the MAX3001EEUP+ in your application.

(For reference only)