Details

---

BUY AD623BRZ https://www.utsource.net/itm/p/12443358.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	V_S		3		36	V
Input Offset Voltage	V_OS		-200	50	200	渭V
Input Bias Current	I_B		-100	1	100	nA
Input Offset Current	I_OS		-50	0.2	50	nA
Common-Mode Rejection Ratio	CMRR	f = 0.1 Hz to 10 kHz	80	94	100	dB
Power-Supply Rejection Ratio	PSRR	f = 10 Hz to 10 kHz	75	85	90	dB
Gain	G		1		1000
Bandwidth (Gain=1)	BW	G = 1		100		kHz
Slew Rate	SR			0.5		V/渭s
Output Voltage Swing	V_O	RL = 10 k惟	-V_S+1.5		V_S-1.5	V
Quiescent Current	I_Q			1.4		mA

Instructions for Use:

1. Power Supply:

   • Ensure the supply voltage is within the specified range of 3V to 36V.
   • The device can operate on a single or dual power supply.

2. Input Signals:

   • The input signals should be within the common-mode input voltage range, which is typically from -Vs + 1.5V to Vs - 1.5V.
   • Avoid exceeding the maximum differential input voltage to prevent damage.

3. Gain Configuration:

   • The gain can be set externally using resistors. For unity gain, connect a resistor between pins 1 and 8.
   • For higher gains, use the formula ( G = 1 + frac{50kOmega} ), where ( R_G ) is the external resistor connected between pins 1 and 8.

4. Output Load:

   • The output can drive loads down to 10 k惟 without significant degradation in performance.
   • Ensure the load resistance does not exceed the output voltage swing capabilities.

5. Operating Temperature:

   • The device is rated for operation over the extended industrial temperature range of -40掳C to +125掳C.

6. PCB Layout Considerations:

   • Keep the input leads short to minimize noise pickup.
   • Use bypass capacitors close to the power supply pins to ensure stable operation.

7. Handling Precautions:

   • This device is sensitive to electrostatic discharge (ESD). Handle with appropriate ESD precautions.
   • Follow proper soldering techniques to avoid thermal damage.

For detailed specifications and more advanced applications, refer to the full datasheet available from the manufacturer.

(For reference only)