Details

---

BUY IM5D05K060M2S https://www.utsource.net/itm/p/12444393.html

Below is the parameter table and instructions for the IM5D05K060M2S:

Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Condition
Input Voltage	Vin	4.5	-	5.5	V
Output Voltage	Vout	3.3	-	3.3	V	Fixed output voltage
Output Current	Iout	-	60	-	mA	Continuous
Efficiency	η	-	85	-	%	At nominal load
Quiescent Current	IQ	-	1.5	-	mA	No load
Operating Temperature	Toper	-40	-	85	°C	Storage and operation
Storage Temperature	Tstg	-55	-	125	°C
Output Ripple Voltage	Vripple	-	30	-	mVpp	At full load
Start-up Time	tstart	-	200	-	μs	From input power to 90% of Vout
Shutdown Current	Ishutdown	-	0.1	-	μA	Shutdown mode

Instructions

1. Mounting and Soldering:

   • Ensure that the component is mounted on a PCB with proper thermal management.
   • Use a soldering iron with a temperature between 260°C and 300°C.
   • Avoid overheating the component during soldering.

2. Input Voltage:

   • The input voltage should be within the range of 4.5V to 5.5V.
   • Ensure that the input voltage is stable to avoid any potential damage or malfunction.

3. Output Voltage:

   • The output voltage is fixed at 3.3V.
   • Verify the output voltage using a multimeter to ensure it meets the specifications.

4. Output Current:

   • The maximum continuous output current is 60mA.
   • Do not exceed this limit to prevent overheating and potential damage.

5. Thermal Management:

   • Ensure adequate heat dissipation by using a heatsink or thermal pad if necessary.
   • Monitor the operating temperature to ensure it stays within the specified range (-40°C to 85°C).

6. Power-Up Sequence:

   • Apply the input voltage slowly to avoid inrush currents.
   • The start-up time from input power to 90% of the output voltage is approximately 200μs.

7. Shutdown Mode:

   • To enter shutdown mode, disconnect the input voltage or use a control signal if available.
   • The shutdown current is typically 0.1μA.

8. Storage:

   • Store the component in a dry, cool place with temperatures between -55°C and 125°C.
   • Avoid exposure to high humidity and corrosive environments.

9. Handling:

   • Handle the component with care to avoid physical damage.
   • Use appropriate ESD (Electrostatic Discharge) protection when handling the component.

10. Testing:

    • Test the component under controlled conditions to ensure it meets the specified parameters.
    • Use a regulated power supply to test the input and output characteristics.

By following these instructions, you can ensure the reliable operation and longevity of the IM5D05K060M2S.

(For reference only)