Details

---

BUY BSM300GB120DLC https://www.utsource.net/itm/p/12508714.html

Parameter	Symbol	Min	Typical	Max	Unit	Conditions
Blocking Voltage (Collector-Emitter)	V(BR)CEO	-	1200	-	V	IC = 300 A, Tc = 25°C
Collector-Emitter Saturation Voltage	VCE(sat)	-	1.8	2.4	V	IC = 300 A, Tc = 25°C, VGE = 15 V
Turn-on Delay Time	td(on)	-	1.6	2.4	μs	IC = 300 A, VGE = 15 V, RL = 100 mΩ
Turn-off Delay Time	td(off)	-	1.2	1.8	μs	IC = 300 A, VGE = 15 V, RL = 100 mΩ
Gate Charge	Qg	-	290	390	nC	IC = 300 A, VGE = 15 V, VCE = 800 V
Total Energy Loss (Switching)	Esw	-	110	150	mJ	IC = 300 A, VCE = 800 V, f = 1 kHz
Continuous Collector Current	IC	-	300	-	A	Tc = 25°C
Pulse Collector Current	ICM	-	600	-	A	tp = 10 ms, Tc = 25°C
Maximum Junction Temperature	TJ(max)	-	-	175	°C	-
Storage Temperature Range	Tstg	-55	-	150	°C	-

Instructions for Use:

1. Mounting and Handling:

   • Ensure that the device is handled with care to avoid mechanical damage.
   • Use appropriate heat sinks to manage thermal dissipation, especially during high current operations.

2. Electrical Connections:

   • Connect the collector (C), emitter (E), and gate (G) terminals correctly.
   • Use short and thick leads to minimize parasitic inductance and resistance.

3. Thermal Management:

   • Monitor the junction temperature (TJ) to ensure it does not exceed 175°C.
   • Use thermal paste between the device and the heat sink to improve thermal conductivity.

4. Gate Drive:

   • Apply a gate-emitter voltage (VGE) of at least 15 V to ensure proper turn-on.
   • Ensure the gate drive circuit can provide sufficient current to charge and discharge the gate capacitance quickly.

5. Overcurrent Protection:

   • Implement overcurrent protection to prevent damage from excessive currents.
   • Consider using a current-limiting resistor or a fast-acting fuse.

6. Switching Frequency:

   • The device is suitable for switching frequencies up to 1 kHz. Higher frequencies may require additional attention to switching losses and thermal management.

7. Storage and Operation:

   • Store the device in a dry environment within the temperature range of -55°C to 150°C.
   • Operate the device within its specified electrical and thermal limits to ensure reliable performance.

8. Testing:

   • Before installation, test the device to ensure it meets the specified parameters.
   • Use a curve tracer or equivalent equipment to verify the blocking voltage and saturation voltage.

By following these instructions, you can ensure optimal performance and longevity of the BSM300GB120DLC.

(For reference only)