Details

---

BUY MX25L8005M2I-12G https://www.utsource.net/itm/p/12510462.html

Parameter	Description	Value	Unit
Device	-	MX25L8005M2I-12G	-
Manufacturer	-	Macronix	-
Package	Package Type	8-SOIC	-
Operating Voltage (Vcc)	Supply Voltage Range	2.7 to 3.6	V
Memory Density	Total Memory Size	8 Mbit	-
Organization	Memory Organization	1 M x 8	-
Page Size	Page Size for Read/Program	256	bytes
Sector Size	Sector Erase Size	4 KBytes	-
Block Size	Block Erase Size	32 KBytes	-
Chip Size	Chip Erase Size	8 Mbit	-
Programming Time	Typical Page Program Time	3	ms
Erase Time	Typical Sector Erase Time	300	ms
Erase Time	Typical Block Erase Time	1500	ms
Erase Time	Typical Chip Erase Time	3000	ms
Endurance	Program/Erase Cycles	100,000	-
Data Retention	Data Retention at 25°C	100	years
Operating Temperature	Industrial Temperature Range	-40 to +85	°C
Storage Temperature	Storage Temperature Range	-65 to +150	°C
Standby Current	Standby Current (Vcc = 3.0V)	1	μA
Active Current	Active Current (Read)	5	mA
Write Current	Write Current (Program/Erase)	10	mA

Instructions

1. Power Supply:

   • Ensure that the supply voltage (Vcc) is within the range of 2.7V to 3.6V.
   • Connect Vcc to the appropriate pin and GND to the ground pin.

2. Pin Configuration:

   • Refer to the datasheet for the specific pin configuration of the 8-SOIC package.
   • Common pins include Vcc, GND, SI (Serial Input), SO (Serial Output), SCK (Serial Clock), and CS (Chip Select).

3. Initialization:

   • Before any operation, ensure that the chip select (CS) is high (inactive).
   • To activate the device, pull CS low.

4. Read Operation:

   • Send the read command (0x03) followed by the starting address.
   • The device will output data from the specified address.

5. Write Operation:

   • Send the write enable command (0x06) to allow writing.
   • Send the page program command (0x02) followed by the starting address and data.
   • Wait for the write cycle to complete before performing another operation.

6. Erase Operation:

   • Send the write enable command (0x06) to allow erasing.
   • For sector erase, send the sector erase command (0x20) followed by the starting address.
   • For block erase, send the block erase command (0x52) followed by the starting address.
   • For chip erase, send the chip erase command (0x60).
   • Wait for the erase cycle to complete before performing another operation.

7. Status Register:

   • To check the status of the device, send the read status register command (0x05).
   • The status register indicates whether the device is busy or ready for new commands.

8. Power Down:

   • When not in use, set CS high to put the device in standby mode, reducing power consumption.

9. Handling Precautions:

   • Handle the device with care to avoid static discharge.
   • Ensure proper grounding and use anti-static wrist straps when handling the device.

For detailed information and additional commands, refer to the official datasheet provided by Macronix.

(For reference only)