MC908QB8CPE

MC908QB8CPE

Category: IC Chips

Specifications
SKU
12510473
Details

BUY MC908QB8CPE https://www.utsource.net/itm/p/12510473.html

Parameter Description Value Unit
Part Number Device Identifier MC908QB8CPE -
Package Type Encapsulation Style TSSOP-20 -
Operating Voltage (VCC) Supply Voltage Range 2.7 to 5.5 V
Operating Temperature (TA) Ambient Operating Temperature Range -40 to +85 °C
Storage Temperature (TSTG) Storage Temperature Range -65 to +150 °C
Clock Frequency (fCY) Maximum Clock Frequency 8 MHz
Flash Memory Non-Volatile Program Memory Size 8 KB
RAM Volatile Data Memory Size 512 B
EEPROM Non-Volatile Data Memory Size 256 B
I/O Pins Number of General Purpose Input/Output Pins 12 -
Analog-to-Digital Converter (ADC) Number of ADC Channels 8 -
ADC Resolution ADC Resolution 10-bit -
Timer Modules Number of Timer Modules 3 -
Serial Communication Interfaces (SCI) Number of SCI Modules 1 -
Synchronous Serial Interface (SPI) Number of SPI Modules 1 -
Inter-Integrated Circuit (I2C) Number of I2C Modules 1 -
Interrupt Sources Total Number of Interrupt Sources 14 -
Watchdog Timer (WDT) Watchdog Timer Availability Yes -
Low-Voltage Detection (LVD) Low-Voltage Detection Availability Yes -
Brown-Out Reset (BOR) Brown-Out Reset Availability Yes -
Power-On Reset (POR) Power-On Reset Availability Yes -
Programming Interface In-Circuit Serial Programming (ICSP) Yes -

Instructions for Use:

  1. Power Supply:

    • Ensure the supply voltage (VCC) is within the specified range of 2.7 to 5.5V.
    • Connect the ground (GND) pin to a stable reference ground.
  2. Clock Configuration:

    • The device supports an internal clock source. For external clock sources, connect an appropriate crystal or oscillator to the XIN and XOUT pins.
  3. Memory Operations:

    • Flash memory can be programmed using the ICSP interface. Refer to the programming manual for specific details.
    • EEPROM data can be read and written during normal operation.
  4. I/O Configuration:

    • Configure the I/O pins as inputs or outputs using the appropriate register settings.
    • Use pull-up or pull-down resistors as needed for input pins.
  5. Peripheral Initialization:

    • Initialize the ADC, timers, and communication interfaces (SCI, SPI, I2C) by setting the corresponding control registers.
    • Enable interrupts if required by setting the interrupt enable bits.
  6. Low-Power Modes:

    • Utilize low-power modes such as idle and stop to reduce power consumption.
    • Configure the watchdog timer (WDT) to prevent system lockup during low-power operation.
  7. Reset Conditions:

    • Ensure that the brown-out reset (BOR) and power-on reset (POR) are enabled to prevent erratic behavior during power-up or low-voltage conditions.
  8. Programming and Debugging:

    • Use a compatible programmer and development environment to write and debug your code.
    • Refer to the device datasheet and programming manual for detailed instructions on using the ICSP interface.

For more detailed information, refer to the official MC908QB8CPE datasheet and application notes provided by the manufacturer.

(For reference only)

View more about MC908QB8CPE on main site