Details

---

BUY DG40F12T2 https://www.utsource.net/itm/p/12510475.html

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VDD	-0.5	-	6.5	V
Input Voltage	VI	-0.5	-	VDD + 0.5	V
Output Voltage	VO	-0.5	-	VDD + 0.5	V
Leakage Current	ILEAK	-	-	1.0	渭A	VDD = 5V, TA = 25掳C
On-State Resistance	RON	-	3.5	-	惟	VDD = 5V, TA = 25掳C
Off-State Resistance	ROFF	100	-	-	M惟	VDD = 5V, TA = 25掳C
Switching Time	tSW	-	10	-	ns	VDD = 5V, TA = 25掳C
Operating Temperature	TOP	-40	-	85	掳C
Storage Temperature	TSTG	-65	-	150	掳C

Instructions for Using DG40F12T2:

1. Power Supply:

   • Ensure the supply voltage (V_DD) is within the range of -0.5V to 6.5V.
   • Avoid exceeding the maximum supply voltage to prevent damage to the device.

2. Input and Output Signals:

   • The input voltage (V_I) should be within the range of -0.5V to V_DD + 0.5V.
   • The output voltage (V_O) should also be within the same range.

3. Leakage Current:

   • Monitor the leakage current (I_LEAK) to ensure it does not exceed 1.0 渭A at V_DD = 5V and T_A = 25掳C.

4. On-State and Off-State Resistances:

   • The on-state resistance (R_ON) is typically 3.5 惟 at V_DD = 5V and T_A = 25掳C.
   • The off-state resistance (R_OFF) is typically 100 M惟 under the same conditions.

5. Switching Time:

   • The switching time (t_SW) is typically 10 ns at V_DD = 5V and T_A = 25掳C.

6. Temperature Considerations:

   • The operating temperature (T_OP) should be between -40掳C and 85掳C.
   • The storage temperature (T_STG) should be between -65掳C and 150掳C.

7. Handling and Storage:

   • Handle the device with care to avoid static discharge and physical damage.
   • Store the device in a dry, cool place to maintain its performance and longevity.

8. Circuit Design:

   • Ensure proper decoupling capacitors are used near the power supply pins to stabilize the supply voltage.
   • Use appropriate pull-up or pull-down resistors for control signals to ensure reliable operation.

9. Testing:

   • Test the device under typical operating conditions to verify its performance.
   • Use a multimeter to measure the on-state and off-state resistances and leakage current.

10. Safety:

    • Follow all safety guidelines and precautions when handling and testing the device.
    • Ensure the device is properly grounded to avoid electrical hazards.

(For reference only)