Details

---

BUY MIP0244SD https://www.utsource.net/itm/p/12510492.html

Parameter	Description	Min	Typ	Max	Unit
Input Voltage (VDD)	Operating voltage range	1.7	-	3.6	V
Standby Current	Current consumption in standby mode	-	0.1	-	μA
Active Current	Current consumption in active mode	-	2.5	-	mA
Output Voltage (VOUT)	Regulated output voltage	1.8	-	3.3	V
Output Current (IOUT)	Maximum continuous output current	-	250	-	mA
Dropout Voltage	Voltage difference between input and output for regulation	-	0.2	-	V
Load Regulation	Change in output voltage due to load changes	-	0.5	-	%
Line Regulation	Change in output voltage due to input voltage changes	-	0.1	-	%
PSRR (Power Supply Rejection Ratio)	Ability to reject ripple from the input supply	-	60	-	dB
Operating Temperature Range	Temperature range for normal operation	-40	-	85	°C
Storage Temperature Range	Temperature range for storage	-55	-	125	°C

Instructions:

1. Power Supply Connection:

   • Connect the input voltage (VDD) within the specified range (1.7V to 3.6V).
   • Ensure the input voltage is stable and free from excessive ripple.

2. Output Configuration:

   • Set the output voltage (VOUT) to the desired value (1.8V to 3.3V) using external resistors if necessary.
   • Verify the output voltage with a multimeter to ensure it meets the required specifications.

3. Load Management:

   • The device can provide up to 250mA of continuous output current.
   • For higher current requirements, consider using additional components or a different regulator.

4. Thermal Considerations:

   • Ensure adequate heat dissipation, especially when operating at high output currents.
   • Use a heatsink if necessary to maintain the operating temperature within the specified range (-40°C to 85°C).

5. Capacitor Selection:

   • Use appropriate input and output capacitors to stabilize the power supply and filter out noise.
   • Recommended values: 1μF ceramic capacitor on the input and 1μF ceramic capacitor on the output.

6. Standby Mode:

   • To enter standby mode, set the enable pin (if available) to a low state.
   • In standby mode, the current consumption is reduced to approximately 0.1μA.

7. Testing and Verification:

   • Test the device under various conditions, including different input voltages and loads.
   • Monitor the output voltage and current to ensure stability and performance.

8. Storage:

   • Store the device in a dry environment within the storage temperature range (-55°C to 125°C).
   • Avoid exposure to extreme temperatures and humidity to prevent damage.

(For reference only)