Details

---

BUY MC68HC11F1CFN4 https://www.utsource.net/itm/p/12530513.html

Parameter	Description	Value / Range
Part Number	Full part identifier	MC68HC11F1CFN4
Package Type	Encapsulation type	40-pin Plastic Dual In-line Package (PDIP)
Operating Voltage (V)	Supply voltage range	5.0 V ± 10%
Operating Temperature	Operating temperature range	-40°C to +85°C
Clock Frequency	Maximum clock frequency	2 MHz
Program Memory	Non-volatile memory for program storage	4 KB EEPROM
Data Memory	RAM for data storage	256 bytes
I/O Ports	Number of I/O lines	32
Timers	Number of timer modules	2
Serial Communication	Available serial interfaces	SCI, SPI
Analog-to-Digital Converter (ADC)	ADC channels and resolution	8-bit, 8 channels
Interrupt Sources	Number of interrupt sources	16
Watchdog Timer	Presence of watchdog timer	Yes

Instructions:

1. Powering the Device:

   • Connect the Vcc pin to a stable 5V power supply.
   • Ensure GND is properly grounded.

2. Clock Configuration:

   • The internal oscillator can be used directly or an external crystal/clock source can be connected depending on the application requirements.

3. Programming:

   • Use a compatible programmer to load code into the EEPROM.
   • Follow the programming guidelines provided in the datasheet for correct voltages and signals.

4. I/O Pin Handling:

   • Configure I/O pins as inputs or outputs using the appropriate registers.
   • Ensure that no I/O pin exceeds the operating voltage limits.

5. Timer Setup:

   • Initialize the timers using the configuration registers.
   • Set up interrupts if needed for timing events.

6. Serial Communication:

   • Configure the SCI and SPI modules as per the communication protocol requirements.
   • Ensure correct baud rates and settings for reliable data transmission.

7. ADC Usage:

   • Select the desired ADC channel and configure the conversion mode.
   • Read the converted values from the ADC result register.

8. Watchdog Timer:

   • Enable the watchdog timer during initialization if required.
   • Service the watchdog periodically to prevent resets.

9. Interrupt Management:

   • Define interrupt service routines for each interrupt source.
   • Enable global interrupts after setting up individual interrupt sources.

10. Testing:

    • Verify all configurations and functionalities through testing with simple programs.
    • Monitor power consumption and ensure it stays within specified limits.

For detailed specifications and advanced usage, refer to the official MC68HC11F1CFN4 datasheet and application notes.

(For reference only)