Details

---

BUY INA117KU https://www.utsource.net/itm/p/12532570.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	-	2.7	-	36	V
Input Voltage Range	VIN	-	-0.3	-	VCC + 0.3	V
Quiescent Current	IQ	VCC = 5V	-	150	-	μA
Output Voltage Swing	VOUT	No Load	0.1	-	VCC - 0.1	V
Common-Mode Rejection Ratio	CMRR	f = 1 kHz	-	98	-	dB
Gain Bandwidth Product	GBW	-	-	400	-	kHz
Input Offset Voltage	VOS	-	-	50	150	μV
Input Bias Current	IB	-	-	20	100	pA
Differential Input Voltage Range	VID	-	-	-	±(VCC - 1.5)	V

Instructions for Use

1. Power Supply:

   • Ensure the supply voltage (V_CC) is within the range of 2.7V to 36V.
   • Connect the power supply to the V_CC pin and ground (GND) pin.

2. Input Connections:

   • Connect the input signals to the non-inverting (IN+) and inverting (IN-) pins.
   • Ensure the input voltages are within the range of -0.3V to V_CC + 0.3V.

3. Output Configuration:

   • The output voltage swing is from 0.1V to V_CC - 0.1V. Ensure the load is properly connected to the output pin (OUT).

4. Biasing and Offset:

   • The input bias current is typically 20pA, but can range up to 100pA. Consider this when designing the input circuitry.
   • The input offset voltage is typically 50μV, but can range up to 150μV. This may need to be compensated for in precision applications.

5. Common-Mode Rejection:

   • The common-mode rejection ratio (CMRR) is 98dB at 1kHz, which helps in rejecting common-mode noise.

6. Gain and Bandwidth:

   • The gain bandwidth product (GBW) is 400kHz, which affects the stability and performance of the amplifier at higher frequencies.

7. Differential Input Voltage:

   • The differential input voltage range is ±(V_CC - 1.5V). Ensure that the difference between IN+ and IN- does not exceed this range to avoid damage or incorrect operation.

8. Thermal Considerations:

   • Ensure adequate heat dissipation if operating at high supply voltages or under high load conditions.

9. Layout and Grounding:

   • Use proper PCB layout techniques to minimize noise and interference. Keep signal traces short and use a ground plane to reduce parasitic capacitance and inductance.

10. Testing and Troubleshooting:

    • Test the device with known input signals to verify correct operation.
    • Use an oscilloscope to monitor the output and input signals for any unexpected behavior.

By following these instructions, you can ensure optimal performance and reliability of the INA117KU instrumentation amplifier.

(For reference only)