Details

---

BUY MAX3488EESA+ https://www.utsource.net/itm/p/12532742.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	2.7	-	5.5	V
Input Current	IIH	VIN = VCC, TA = 25°C	-	1	-	μA
Output Current	IOH	VOL = 0.4V, TA = 25°C	8	-	-	mA
Standby Current	ISB	RS = 1kΩ, VCC = 5V, DE = 0V	1	-	-	μA
Driver Enable Input High Voltage	VIH	IIN = 1μA, TA = 25°C	2.0	-	VCC	V
Driver Enable Input Low Voltage	VIL	IIN = 1μA, TA = 25°C	0	-	0.8	V
Data Rate		Differential	-	250	-	Mbps
Propagation Delay	tPD	RL = 100Ω, CL = 30pF	12	-	-	ns
Skew	tSKEW	RL = 100Ω, CL = 30pF	-	2	-	ns

Instructions for Use:

1. Power Supply Connection: Connect the VCC pin to a power supply within the range of 2.7V to 5.5V. Ensure GND is properly grounded.

2. Driver Enable Control: The DE pin controls the driver enable. Apply a voltage greater than VIH to enable the driver and less than VIL to disable it.

3. Data Transmission: For differential data transmission, connect the differential input pins (DI+/DI-) and output pins (RO+/RO-). The device supports up to 250 Mbps data rate.

4. Standby Mode: To minimize power consumption, set DE low. The device will enter standby mode with ISB current.

5. Propagation Delay Consideration: Account for a propagation delay of up to 12ns when designing your timing requirements.

6. Signal Integrity: To maintain signal integrity, use appropriate termination resistors (RL) and keep capacitance (CL) as specified in the table.

7. Environmental Conditions: Ensure that the operating temperature and other environmental conditions are within the specifications provided by the manufacturer.

Note: Always refer to the official datasheet from Maxim Integrated for the most accurate and detailed information.

(For reference only)