Details

---

BUY AD536AJQ https://www.utsource.net/itm/p/12532826.html

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VCC	4.75	5	5.25	V
Output Voltage Range	VOUT	0	-	VCC	V
Input Voltage Range	VIN	0	-	VCC	V
Input Current	IIN	-	100	-	μA
Output Current	IOUT	-	10	-	mA
Power Consumption	PCON	-	10	-	mW
Temperature Range	TAMB	-40	-	85	°C
Quiescent Current	IQ	-	2	-	mA
Line Regulation	LREG	-	0.01	-	%/V
Load Regulation	LDR	-	0.01	-	%/mA
Accuracy	ACCURACY	-	0.1	-	%
Bandwidth	BW	-	10	-	kHz
Settling Time (10-90%)	tSETTLE	-	10	-	μs
Noise (0.1 to 10 Hz)	NOISE	-	5	-	μVp-p

Instructions for Using AD536AJQ

1. Power Supply:

   • Ensure the supply voltage (VCC) is within the range of 4.75V to 5.25V.
   • Connect the power supply to the VCC pin and ground to the GND pin.

2. Input Connection:

   • Connect the input signal to the VIN pin. The input voltage should be within the range of 0V to VCC.
   • Ensure the input current does not exceed 100 μA.

3. Output Configuration:

   • The output voltage (VOUT) can range from 0V to VCC.
   • The maximum output current (IOUT) is 10 mA. Ensure the load does not draw more than this current.

4. Temperature Considerations:

   • The device operates over a temperature range of -40°C to 85°C. Ensure the ambient temperature stays within these limits.

5. Power Consumption:

   • The typical power consumption is 10 mW. Monitor the power usage to avoid overheating.

6. Quiescent Current:

   • The quiescent current (IQ) is typically 2 mA. This is the current drawn by the device when no load is connected.

7. Regulation:

   • The line regulation (LREG) and load regulation (LDR) are both very low at 0.01% per volt and per milliamp, respectively. This ensures stable output under varying conditions.

8. Accuracy:

   • The device has a typical accuracy of 0.1%, ensuring precise output voltage.

9. Bandwidth and Settling Time:

   • The bandwidth is 10 kHz, suitable for most analog applications.
   • The settling time from 10% to 90% of the final value is 10 μs, indicating a fast response time.

10. Noise:

    • The noise level is 5 μVp-p over the frequency range of 0.1 to 10 Hz, ensuring a clean output signal.

11. Handling and Storage:

    • Handle the device with care to avoid damage from static electricity.
    • Store the device in a dry, cool place away from direct sunlight and extreme temperatures.

12. Troubleshooting:

    • If the output voltage is not as expected, check the input voltage and connections.
    • If the device is overheating, ensure proper heat dissipation and check the power supply and load conditions.

(For reference only)