Details

---

BUY ADS1210U https://www.utsource.net/itm/p/12534365.html

Parameter	Symbol	Min	Typical	Max	Units	Notes
Supply Voltage	VDD	2.7	-	5.5	V
Operating Temperature	Toperating	-40	-	85	°C
Input Voltage Range	VIN	0	-	VDD	V
Output Data Rate	ODR	20	-	2000	SPS
Resolution	Res	-	24-bit	-	bits
Differential Inputs	N/A	-	2	-	ch
Single-Ended Inputs	N/A	-	4	-	ch
Power Consumption	ICC	-	1.5	-	mA	@3.3V
Gain	G	1	-	128	-
Common Mode Rejection	CMRR	-	90	-	dB	@60Hz
Signal-to-Noise Ratio	SNR	-	102	-	dB
Offset Drift	ODRIFT	-	0.5	-	μV/°C
Gain Drift	GDRIFT	-	10	-	ppm/°C
Package	N/A	-	TSSOP-16	-	-

Instructions for Using the ADS1210U:

1. Power Supply:

   • Ensure the supply voltage (VDD) is within the range of 2.7V to 5.5V.
   • Connect the ground (GND) pin to a stable ground reference.

2. Input Configuration:

   • The ADS1210U supports both differential and single-ended inputs.
   • For differential inputs, connect the signals to the appropriate differential input pairs (AIN0, AIN1, AIN2, AIN3).
   • For single-ended inputs, connect the signals to the single-ended input pins (AIN0, AIN1, AIN2, AIN3) with respect to GND.

3. Output Data Rate (ODR):

   • Set the desired output data rate (ODR) using the configuration registers.
   • The ODR can be set between 20 SPS and 2000 SPS.

4. Gain Setting:

   • Adjust the gain using the configuration registers.
   • The gain can be set from 1 to 128.

5. Configuration Registers:

   • Use the I2C or SPI interface to write to the configuration registers.
   • Refer to the datasheet for the specific register addresses and bit configurations.

6. Data Readout:

   • Read the conversion results from the data register via the I2C or SPI interface.
   • Ensure the readout is synchronized with the selected ODR to avoid data loss.

7. Calibration:

   • Perform system calibration if necessary to correct for offset and gain errors.
   • Use the internal calibration functions provided by the ADS1210U.

8. Power Management:

   • Use the power-down mode to reduce power consumption when the ADC is not in use.
   • Re-enable the ADC by writing to the appropriate register when measurements are needed again.

9. Environmental Considerations:

   • Operate the device within the specified temperature range (-40°C to 85°C).
   • Ensure proper thermal management to avoid overheating.

10. Electromagnetic Compatibility (EMC):

    • Implement proper PCB layout and shielding techniques to minimize electromagnetic interference.
    • Use decoupling capacitors close to the power supply pins to filter noise.

For detailed information, refer to the ADS1210U datasheet and application notes provided by the manufacturer.

(For reference only)