Details

---

BUY OPA4374AID https://www.utsource.net/itm/p/12534738.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	-	2.7	-	5.5	V
Quiescent Current	IQ	VCC = 3V, No Load	-	100	-	渭A
Input Offset Voltage	VOS	VCC = 3V, TA = 25掳C	-15	0	15	渭V
Input Bias Current	IB	VCC = 3V, TA = 25掳C	-	0.5	-	pA
Slew Rate	SR	VCC = 3V	0.4	-	-	V/渭s
Bandwidth (Small Signal)	fT	VCC = 3V, G = +1	-	1.6	-	MHz
Output Voltage Swing	VO	VCC = 3V, RL = 1k惟	0.2	-	2.8	V

Instructions for OPA4374AID

1. Power Supply:

   • Operate the device within the specified supply voltage range of 2.7V to 5.5V.

2. Quiescent Current:

   • Ensure that the quiescent current does not exceed 100渭A at a supply voltage of 3V with no load.

3. Input Signals:

   • Keep input signals within the common-mode input voltage range to avoid distortion.
   • Be aware of the input offset voltage which can be up to 卤15渭V at room temperature.

4. Bias Current:

   • The typical input bias current is 0.5pA, so use high impedance sources to minimize error.

5. Slew Rate:

   • Consider the slew rate of 0.4V/渭s when designing circuits requiring fast transient response.

6. Bandwidth:

   • For small signal applications, note the unity gain bandwidth of 1.6MHz.

7. Output Configuration:

   • Ensure the output voltage swing is within the limits (0.2V to 2.8V) when using a 3V supply and a 1k惟 load resistor.

8. Thermal Management:

   • Maintain proper heat dissipation if operating near maximum supply voltage or under heavy loads.

9. Handling Precautions:

   • Handle the device carefully to avoid damage from electrostatic discharge (ESD).

10. Circuit Design:

    • Use bypass capacitors close to the power supply pins to ensure stable operation.

For detailed specifications and additional information, refer to the official datasheet provided by the manufacturer.

(For reference only)