Details

---

BUY LM35DT https://www.utsource.net/itm/p/12535027.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Operating Voltage	VCC	Continuous Operation	4.0	5.0	30.0	V
Supply Current	IS	VCC = 5V	-	60	-	μA
Output Impedance	ZO	-	-	0.1	-	Ω
Temperature Sensitivity	ST	-	9.0	10.0	11.0	mV/°C
Temperature Range	TA	-	-55	-	150	°C
Thermal Response Time	τT	-	-	250	-	ms

Instructions for Using LM35DT

1. Power Supply:

   • The LM35DT operates over a wide range of supply voltages from 4V to 30V.
   • Ensure the supply voltage is within the specified range to avoid damage.

2. Temperature Measurement:

   • The output voltage of the LM35DT is directly proportional to the temperature in Celsius.
   • The typical sensitivity is 10 mV/°C.
   • For example, at 25°C, the output voltage will be 250 mV.

3. Circuit Connections:

   • Connect the positive terminal (V_CC) to the power supply.
   • Connect the negative terminal (GND) to ground.
   • The output terminal (V_OUT) provides the temperature-dependent voltage.

4. Output Filtering:

   • To reduce noise, a 10 μF capacitor can be placed between the output and ground.

5. Thermal Considerations:

   • The thermal response time is approximately 250 ms.
   • Place the sensor in direct contact with the surface whose temperature you are measuring to ensure accurate readings.

6. Operating Temperature Range:

   • The sensor can operate from -55°C to 150°C.
   • Ensure the sensor is not exposed to temperatures outside this range to prevent damage or inaccurate readings.

7. Calibration:

   • The sensor is factory-calibrated and typically does not require additional calibration.
   • If necessary, calibration can be performed by comparing the output voltage to a known temperature reference.

8. Handling:

   • Handle the sensor with care to avoid physical damage.
   • Avoid exposing the sensor to extreme environmental conditions such as high humidity or corrosive gases.

By following these instructions, you can ensure accurate and reliable temperature measurements using the LM35DT.

(For reference only)