Details

---

BUY IR2156S SMD https://www.utsource.net/itm/p/12535322.html

Below is the parameter table and instructions for the IR2156S SMD:

IR2156S SMD Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage (High-Side)	VBB	10	-	60	V
Supply Voltage (Low-Side)	VSS	4.5	-	20	V
Logic Input High Level	VILH	-	3.3	5.5	V
Logic Input Low Level	VILL	0	-	0.8	V
Output High-Level Voltage	VOH	-	14	-	V
Output Low-Level Voltage	VOL	-	0.5	-	V
Output Current (Source)	IOH	-	1.5	-	A
Output Current (Sink)	IOL	-	1.5	-	A
Propagation Delay Time	td	50	100	150	ns
Minimum Pulse Width	tmin	100	-	-	ns
Operating Temperature Range	TA	-40	-	125	°C
Storage Temperature Range	TSTG	-55	-	150	°C

IR2156S SMD Instructions

1. Supply Voltage:

   • Connect the high-side supply voltage (V_BB) to the appropriate pin.
   • Connect the low-side supply voltage (V_SS) to the appropriate pin.

2. Logic Inputs:

   • Apply logic high (V_ILH) or logic low (V_ILL) signals to the input pins to control the high-side and low-side outputs.

3. Output Pins:

   • The output pins (HO and LO) will drive the gate of the high-side and low-side MOSFETs, respectively.
   • Ensure that the load connected to the output pins does not exceed the maximum output current (I_OH and I_OL).

4. Propagation Delay:

   • Be aware of the propagation delay time (t_d) when designing your timing circuits to avoid any potential issues.

5. Minimum Pulse Width:

   • Ensure that the minimum pulse width (t_min) is respected to prevent improper operation.

6. Temperature Considerations:

   • Operate the device within the specified operating temperature range (T_A).
   • Store the device within the specified storage temperature range (T_STG).

7. PCB Layout:

   • Use proper PCB layout techniques to minimize noise and ensure reliable operation.
   • Keep the ground connections short and direct to reduce ground bounce.

8. Protection:

   • Implement appropriate protection circuits (e.g., flyback diodes for inductive loads) to protect the device from overvoltage and overcurrent conditions.

By following these parameters and instructions, you can ensure optimal performance and reliability of the IR2156S SMD in your application.

(For reference only)