Details

---

BUY TL071 https://www.utsource.net/itm/p/12535344.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage Range	VCC	-	±4	-	±18	V
Input Offset Voltage	VIO	-	-	3	-	mV
Input Bias Current	IB	-	-	80	-	nA
Input Offset Current	IOS	-	-	20	-	nA
Input Resistance	RI	-	-	1012	-	Ω
Differential Input Voltage Range	VID	-	-VCC+2	-	VCC-2	V
Common-Mode Rejection Ratio	CMRR	-	-	96	-	dB
Large Signal Voltage Gain	AV(OL)	f = 0 Hz	-	200	-	V/mV
Slew Rate	SR	VO=±10V, RL=2kΩ	-	13	-	V/μs
Output Short-Circuit Duration	tSC	-	-	Indefinite	-	s

Instructions for Using TL071

1. Power Supply Connection:

   • Connect the power supply to the V_CC and V_EE pins ensuring that the voltage levels are within the specified range (±4V to ±18V).

2. Input Configuration:

   • The differential input voltage should not exceed the supply voltages by more than 2V.
   • Ensure that the common-mode voltage remains within the operational limits.

3. Biasing:

   • For optimal performance, use a split power supply configuration.
   • If using a single supply, ensure proper biasing of the inputs to avoid distortion.

4. Output Load:

   • The output can drive loads as low as 2kΩ. Ensure that the load resistance is appropriate for the application.

5. Handling Static Electricity:

   • The TL071 has high input impedance; handle with care to avoid damage from static electricity.

6. Operating Temperature:

   • Ensure that the operating temperature does not exceed the rated limits to prevent degradation or failure.

7. Stability Considerations:

   • Use compensation capacitors if necessary to maintain stability, especially at higher frequencies.

8. Slew Rate Limitation:

   • Be aware of the slew rate limitation (13V/μs) which may affect large signal response times.

9. Short Circuit Protection:

   • The device offers indefinite short-circuit protection on the output. However, prolonged shorts can still cause heating and potential damage.

10. Storage and Handling:

    • Store in a dry environment and handle with anti-static precautions to protect against ESD damage.

(For reference only)