Details

---

BUY MC68HC705SR3P https://www.utsource.net/itm/p/12535405.html

Parameter	Description	Value/Range
Package Type	The type of package used for the component	28-pin PDIP (Plastic Dual In-line Package)
Operating Voltage (VCC)	Supply voltage range	4.75 V to 5.25 V
Temperature Range	Operating temperature range	-40°C to +85°C
Clock Frequency	Maximum clock frequency	Up to 4 MHz
RAM Size	Internal RAM size	128 bytes
EEPROM Size	Internal EEPROM size	256 bytes
Program Memory	Program memory size	4 KB ROM
I/O Ports	Number of I/O ports available	20-bit bidirectional I/O ports
Interrupt Sources	Types of interrupt sources supported	Maskable and non-maskable interrupts
Timer	Number of timers	1 x 8-bit timer
Watchdog Timer	Watchdog timer functionality	Yes
Serial Communication	Serial communication interfaces	SCI (Serial Communication Interface)

Instructions for Use:

1. Power Supply: Ensure the supply voltage is within the specified range (4.75 V to 5.25 V). External power regulation may be necessary.
2. Clock Setup: Connect an external crystal or use internal RC oscillator based on application needs. For crystals, ensure they are within the supported frequency range.
3. Reset Circuit: Implement a reset circuit that provides a clean reset signal. A typical reset circuit includes a capacitor and resistor connected to the reset pin.
4. Programming: Use an appropriate programmer to load code into the ROM. Follow manufacturer guidelines for programming procedures.
5. I/O Configuration: Configure I/O ports as inputs or outputs as required by your application. Refer to the datasheet for specific port configurations.
6. Interrupt Handling: Set up interrupt vectors and service routines in program memory. Enable interrupts using the appropriate control registers.
7. Timer Usage: Initialize the timer module according to the timing requirements of your application. Use timer interrupts for periodic tasks.
8. Watchdog Timer: Enable and configure the watchdog timer to prevent system lockup. Adjust the timeout period as needed.
9. Serial Communication: Configure the SCI for serial data transmission and reception. Set baud rates and other parameters as per communication protocol.

For detailed information, refer to the official MC68HC705SR3P datasheet provided by the manufacturer.

(For reference only)