Details

---

BUY TLP641 https://www.utsource.net/itm/p/12536122.html

Parameter	Symbol	Min	Typ	Max	Unit
Forward Voltage	VF	-	1.2	1.5	V
Peak Forward Current	IFP	-	10	15	A
Repetitive Peak Reverse Voltage	VRRM	500	-	700	V
Non-Repetitive Peak Reverse Voltage	VRRMS	700	-	1000	V
Reverse Leakage Current	IR	-	100	500	μA
Storage Temperature Range	Tstg	-40	-	100	°C
Operating Temperature Range	Topr	-40	-	100	°C
Isolation Voltage	VIORM	2500	-	3750	Vrms
Turn-On Time	ton	-	3	5	μs
Turn-Off Time	toff	-	3	5	μs

Instructions for TLP641

1. Handling Precautions:

   • Handle the device with care to avoid mechanical damage.
   • Use appropriate ESD (Electrostatic Discharge) protection measures.

2. Mounting and Soldering:

   • Ensure that the mounting surface is clean and free from contaminants.
   • Use a soldering iron with a temperature setting of 260°C or less.
   • Do not apply excessive heat or pressure during soldering.

3. Forward Current (IF):

   • The peak forward current (IFP) should not exceed 15A to prevent damage to the device.
   • For continuous operation, ensure that the forward current does not exceed the typical value of 10A.

4. Reverse Voltage (VR):

   • The repetitive peak reverse voltage (VRRM) should not exceed 700V.
   • For non-repetitive conditions, the peak reverse voltage (VRRMS) should not exceed 1000V.

5. Temperature Considerations:

   • The storage temperature range (Tstg) is -40°C to 100°C.
   • The operating temperature range (Topr) is also -40°C to 100°C.
   • Ensure that the device operates within these temperature limits to avoid thermal stress.

6. Isolation Voltage:

   • The isolation voltage (VIORM) should be maintained at 2500Vrms or higher to ensure proper insulation.

7. Timing Parameters:

   • The turn-on time (ton) and turn-off time (toff) are typically 3μs, with a maximum of 5μs.
   • Design the circuit to accommodate these timing parameters to ensure reliable operation.

8. Storage and Transportation:

   • Store the device in a dry, cool place away from direct sunlight.
   • Use static-shielded bags for transportation to protect against ESD.

9. Testing:

   • Before installing the device in a circuit, perform initial testing to verify its functionality.
   • Use a multimeter or appropriate test equipment to check the forward voltage (VF) and other parameters.

10. Compliance:

    • Ensure that the device complies with all relevant safety and regulatory standards for your application.

(For reference only)