Details

---

BUY XC9536VQ44AEM-15C https://www.utsource.net/itm/p/12536130.html

Parameter	Description	Value
Device Type	CPLD (Complex Programmable Logic Device)	XC9536VQ44AEM-15C
Family	XC9500XL	-
Package	VQFP (Very Thin Quad Flat Package)	44-Pin
Operating Voltage (Vcc)	Supply Voltage	3.3V ± 5%
Maximum Frequency (fMAX)	Maximum Clock Frequency	150 MHz
I/O Banks	Number of I/O Banks	4
I/O Pins	Number of I/O Pins	36
Macrocells	Number of Macrocells	36
Internal Oscillator	Internal Oscillator Availability	No
External Oscillator	External Oscillator Support	Yes
Configuration Modes	Configuration Modes Supported	ISP (In-System Programming), JTAG, Master Serial, Slave Serial
Configuration Memory	Non-Volatile Configuration Memory	No
Power Consumption	Typical Power Consumption	10 mW (quiescent), 100 mW (active)
Operating Temperature Range	Industrial Temperature Range	-40°C to +85°C
Storage Temperature Range	Storage Temperature Range	-65°C to +150°C
ESD Protection	Electrostatic Discharge Protection	HBM: 2000V, MM: 200V
Package Material	Package Material	Lead-Free, Halogen-Free
Compliance	Compliance Standards	RoHS, REACH

Instructions for Use:

1. Power Supply:

   • Ensure that the Vcc supply voltage is within the specified range of 3.3V ± 5%.
   • Use appropriate decoupling capacitors (e.g., 0.1μF and 10μF) placed close to the power pins to reduce noise and ensure stable operation.

2. Configuration:

   • The device supports multiple configuration modes including ISP (In-System Programming), JTAG, Master Serial, and Slave Serial.
   • Use the appropriate configuration software and hardware to program the device according to the selected mode.
   • For ISP, ensure that the programming interface is connected correctly and that the programming software is configured with the correct settings.

3. Clocking:

   • The device does not have an internal oscillator; an external clock source must be provided.
   • Ensure that the external clock signal is stable and within the maximum frequency limit of 150 MHz.

4. I/O Handling:

   • Configure the I/O pins as inputs or outputs based on your application requirements.
   • Use pull-up or pull-down resistors if necessary to ensure proper logic levels.
   • Be cautious with ESD (Electrostatic Discharge) when handling the device; use ESD protection measures such as wrist straps and grounded work surfaces.

5. Thermal Management:

   • Ensure adequate cooling if the device is operating in high-temperature environments or under heavy load conditions.
   • Refer to the thermal resistance data in the datasheet to estimate the junction temperature and take necessary steps to keep it within safe limits.

6. Storage and Handling:

   • Store the device in a dry, cool place within the specified storage temperature range.
   • Handle the device with care to avoid mechanical damage and ESD.

7. Compliance:

   • Ensure that the device and its application comply with relevant standards and regulations such as RoHS and REACH.

(For reference only)