Details

---

BUY TLC1549CP https://www.utsource.net/itm/p/12541493.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	Operating	2.7	-	5.5	V
Input Voltage Range	VIN	-	0	-	VCC	V
Output Logic High Voltage	VOH	IO = -0.4 mA	-	0.9VCC	VCC - 0.1	V
Output Logic Low Voltage	VOL	IO = 4.0 mA	0	0.1	-	V
Conversion Time	tC	-	-	22	-	μs
Power Consumption	Ptot	-	-	1.0	-	mW
Input Impedance	RIN	-	10	-	-	MΩ
Temperature Range	TA	Operating	-40	-	85	°C
Storage Temperature	TSTG	-	-40	-	125	°C

Instructions for Using TLC1549CP:

1. Power Supply:

   • Ensure that the supply voltage (V_CC) is within the range of 2.7V to 5.5V.
   • Connect the ground (GND) pin to the system ground.

2. Input Signal:

   • The input voltage (V_IN) should be within the range of 0V to V_CC.
   • Ensure that the input signal does not exceed the supply voltage to avoid damage.

3. Output Logic Levels:

   • The output logic high voltage (V_OH) will be approximately 0.9V_CC when the output current (I_O) is -0.4 mA.
   • The output logic low voltage (V_OL) will be less than 0.1V when the output current (I_O) is 4.0 mA.

4. Conversion Time:

   • The typical conversion time (t_C) is 22 μs. Ensure that your system allows sufficient time for the ADC to complete a conversion before reading the result.

5. Power Consumption:

   • The typical power consumption (P_tot) is 1.0 mW. This should be considered in power-sensitive applications.

6. Input Impedance:

   • The input impedance (R_IN) is 10 MΩ. This high impedance allows the TLC1549CP to interface with high-impedance sources without significant loading.

7. Temperature Considerations:

   • The operating temperature range (T_A) is from -40°C to 85°C.
   • The storage temperature range (T_STG) is from -40°C to 125°C. Store the device in a dry, cool place to ensure long-term reliability.

8. Handling and ESD Protection:

   • Handle the TLC1549CP with care to avoid electrostatic discharge (ESD) damage.
   • Use proper ESD protection measures such as wrist straps and ESD-safe workstations.

9. Interfacing:

   • Connect the TLC1549CP to a microcontroller or other digital system using the appropriate SPI or I2C interface (depending on the variant).
   • Refer to the datasheet for specific pin configurations and communication protocols.

10. Testing and Calibration:

    • After installation, test the TLC1549CP with known input voltages to ensure accurate conversions.
    • Calibrate the ADC if necessary to achieve the desired accuracy.

By following these instructions, you can ensure reliable and accurate operation of the TLC1549CP in your application.

(For reference only)