Details

---

BUY RDA5876 https://www.utsource.net/itm/p/12541848.html

Parameter	Symbol	Min	Typ	Max	Unit	Description
Operating Voltage	VDD	2.8	3.3	3.6	V	Supply voltage
Operating Current	IDD	-	40	-	mA	Active mode current
Standby Current	ISB	-	1	-	μA	Standby mode current
Frequency Range	fR	76	-	108	MHz	FM reception range
Sensitivity	S	-	-100	-	dBμV	Signal sensitivity at 12dB SINAD
Selectivity	SEL	-	12	-	dB	Channel selectivity at 200kHz offset
Image Rejection	IMR	-	60	-	dB	Image rejection
Spurious Rejection	SPR	-	70	-	dB	Spurious rejection
Intermodulation Ratio	IMR	-	60	-	dBc	Third-order intermodulation ratio
Output Power	POUT	-	2.2	-	mW	Maximum output power (line out)
Output Impedance	ZOUT	-	4	-	kΩ	Output impedance (line out)
Audio SNR	SNR	-	60	-	dB	Audio signal-to-noise ratio
Temperature Range	Toper	-40	-	85	°C	Operating temperature range

Instructions for Using RDA5876

1. Power Supply:

   • Connect the VDD pin to a 2.8V to 3.6V power supply.
   • Ensure the power supply is stable and has sufficient current capacity.

2. Grounding:

   • Connect all ground pins (GND) to a common ground plane to ensure proper operation and minimize noise.

3. Antenna Connection:

   • Connect an appropriate antenna to the ANT pin. The antenna should be tuned to the FM frequency range (76-108 MHz).

4. External Components:

   • Use the recommended external components (capacitors, inductors, etc.) as specified in the datasheet to ensure optimal performance.
   • Place decoupling capacitors close to the power supply pins to filter out noise.

5. Configuration:

   • Use the I2C interface to configure the RDA5876. Refer to the datasheet for specific register addresses and values.
   • Set the desired parameters such as frequency, volume, and other settings via the I2C interface.

6. Audio Output:

   • Connect the audio output pins (Lout, Rout) to an amplifier or headphones.
   • Adjust the volume and other audio settings using the I2C interface.

7. Standby Mode:

   • To enter standby mode, set the appropriate register bit via the I2C interface.
   • In standby mode, the device consumes minimal power (typically 1 μA).

8. Temperature Considerations:

   • Ensure the operating temperature remains within the specified range (-40°C to 85°C).
   • Avoid placing the device near heat sources that could exceed the maximum temperature.

9. Testing and Troubleshooting:

   • Verify the power supply and ground connections before testing.
   • Use a spectrum analyzer or oscilloscope to check the signal quality and performance.
   • Refer to the troubleshooting section in the datasheet for common issues and solutions.

(For reference only)