Details

---

BUY TLC2262AIDR https://www.utsource.net/itm/p/12542679.html

Below is the parameter table and instructions for the TLC2262AIDR, which is a low-power, single-supply operational amplifier from Texas Instruments.

TLC2262AIDR Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VCC	2.7	-	5.5	V	-
Input Offset Voltage	VIO	-	1.5	4.0	mV	-
Input Bias Current	IB	-	15	30	nA	-
Input Offset Current	IOS	-	2.0	4.0	nA	-
Input Voltage Range	VIN	VEE + 0.3	-	VCC - 0.3	V	-
Output Voltage Swing (Low)	VOL	0.0	0.01	0.1	V	IOL = 1 mA
Output Voltage Swing (High)	VOH	VCC - 0.1	VCC - 0.01	VCC - 0.0	V	IOH = -1 mA
Slew Rate	SR	-	0.5	1.0	V/μs	-
Gain Bandwidth Product	GBP	-	1.0	1.5	MHz	-
Power Supply Rejection Ratio	PSRR	-	80	90	dB	f = 1 kHz
Common-Mode Rejection Ratio	CMRR	-	80	90	dB	f = 1 kHz
Quiescent Current	IQ	-	100	200	μA	-
Operating Temperature Range	TA	-40	-	85	°C	-

Instructions for TLC2262AIDR

1. Supply Voltage:

   • Ensure the supply voltage (V_CC) is within the range of 2.7V to 5.5V.
   • Connect V_CC to the positive power supply and V_EE to ground or a negative supply if applicable.

2. Input Signals:

   • The input signals should be within the input voltage range, which is from V_EE + 0.3V to V_CC - 0.3V.
   • Avoid exceeding these limits to prevent damage to the device.

3. Output Signals:

   • The output voltage swing is typically from 0.01V to V_CC - 0.01V when sourcing or sinking 1 mA.
   • For optimal performance, ensure the load does not exceed the maximum current ratings.

4. Power Supply Decoupling:

   • Place a 0.1 μF ceramic capacitor close to the V_CC and V_EE pins to minimize noise and improve stability.

5. Temperature Considerations:

   • The operating temperature range is from -40°C to 85°C. Ensure the ambient temperature stays within this range to maintain reliable operation.

6. Layout and PCB Design:

   • Use a good grounding technique to minimize noise and improve performance.
   • Keep signal traces as short as possible to reduce parasitic capacitance and inductance.

7. Handling and Storage:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage.
   • Store the device in a dry, cool place to prevent moisture damage.

By following these parameters and instructions, you can ensure the TLC2262AIDR operates reliably and efficiently in your circuit.

(For reference only)