Details

---

BUY MCP6002-I/P https://www.utsource.net/itm/p/12542693.html

Below is the parameter table and instructions for the MCP6002-I/P, a dual operational amplifier from Microchip Technology.

MCP6002-I/P Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	VDD	1.8	-	6.0	V	-
Quiescent Current per Amplifier	IQ	-	150	-	nA	VDD = 5V
Input Bias Current	IB	-	30	-	pA	VDD = 5V
Input Offset Voltage	VOS	-1.5	0	1.5	mV	VDD = 5V
Input Voltage Range	VIN	0	-	VDD - 1.2	V	-
Output Voltage Swing	VOUT	0.4	-	VDD - 0.4	V	-
Slew Rate	SR	-	0.5	-	V/渭s	VDD = 5V
Gain Bandwidth Product	GBP	-	100	-	kHz	VDD = 5V
Common Mode Rejection Ratio	CMRR	-	80	-	dB	VDD = 5V
Power Supply Rejection Ratio	PSRR	-	80	-	dB	VDD = 5V

Instructions for Using the MCP6002-I/P

1. Power Supply:

   • The MCP6002-I/P operates on a single supply voltage ranging from 1.8V to 6.0V.
   • Ensure that the power supply is stable and within the specified range to avoid damage to the device.

2. Pin Configuration:

   • Pin 1 (V_DD): Connect to the positive supply voltage.
   • Pin 2 (IN-1): Inverting input of the first op-amp.
   • Pin 3 (IN+1): Non-inverting input of the first op-amp.
   • Pin 4 (OUT1): Output of the first op-amp.
   • Pin 5 (IN-2): Inverting input of the second op-amp.
   • Pin 6 (IN+2): Non-inverting input of the second op-amp.
   • Pin 7 (OUT2): Output of the second op-amp.
   • Pin 8 (V_SS): Connect to ground (0V).

3. Input and Output Signals:

   • The input voltage range should be between 0V and V_DD - 1.2V to ensure proper operation.
   • The output voltage swing is typically 0.4V above ground and 0.4V below V_DD.

4. Biasing and Decoupling:

   • Use decoupling capacitors (typically 0.1渭F) close to the power supply pins (V_DD and V_SS) to filter out noise and stabilize the supply voltage.
   • If necessary, use biasing resistors to set the operating point of the op-amps, especially in non-inverting configurations.

5. Operational Considerations:

   • The MCP6002-I/P has a high input impedance and low output impedance, making it suitable for a wide range of applications including signal conditioning, filtering, and amplification.
   • Ensure that the input signals do not exceed the common mode input range to avoid distortion or damage.

6. Temperature Range:

   • The MCP6002-I/P is designed to operate over a temperature range of -40掳C to +125掳C. However, performance parameters may vary with temperature, so refer to the datasheet for detailed temperature characteristics.

7. Storage and Handling:

   • Store the device in a dry environment to prevent moisture damage.
   • Handle the device with care to avoid static discharge, which can damage sensitive components.

By following these instructions and guidelines, you can effectively use the MCP6002-I/P in your electronic designs.

(For reference only)