Details

---

BUY TL084IDR https://www.utsource.net/itm/p/12542731.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	±VCC = ±2 to ±18V	4	15	36	V
Input Voltage Range	VI	Relative to Ground	-13	0	13	V
Output Voltage Swing	VO	No Load, ±15V Supply	-13	0	13	V
Output Current	IO	Short-Circuit Protection	-	10	-	mA
Slew Rate	SR	VCC = ±15V	13	-	-	V/μs
Bandwidth (Unity Gain)	fT	VCC = ±15V	3	-	-	MHz
Open Loop Gain	AVOL	VCC = ±15V, f = 1kHz	100	-	-	dB
Input Offset Voltage	VIO	VCC = ±15V	-5	0	5	mV
Input Bias Current	IB	VCC = ±15V	-	50	-	nA
Input Offset Current	IIO	VCC = ±15V	-	10	-	nA
Common Mode Rejection Ratio	CMRR	VCC = ±15V, f = 60Hz	80	-	-	dB
Power Consumption	PD	Per Amplifier, VCC = ±15V	-	1.5	-	mW

Instructions for Use:

1. Power Supply:

   • The TL084IDR can operate with a supply voltage range from ±2V to ±18V.
   • Ensure that the power supply is stable and within the specified range to avoid damage to the device.

2. Input Voltage:

   • The input voltage should be within the range of -13V to +13V relative to ground to prevent clipping or distortion.
   • Avoid exceeding these limits to prevent damage to the input stage.

3. Output Voltage:

   • The output voltage swing is typically -13V to +13V with no load and a ±15V supply.
   • The output current is limited to 10mA to protect against short circuits.

4. Slew Rate:

   • The slew rate of 13V/μs indicates the maximum rate at which the output voltage can change. This is important for high-frequency applications.

5. Bandwidth:

   • The unity gain bandwidth is 3MHz, which is suitable for a wide range of analog signal processing applications.

6. Open Loop Gain:

   • The open loop gain is 100dB at 1kHz, providing high gain for small signal amplification.

7. Input Offset Voltage:

   • The input offset voltage is ±5mV, which can affect the accuracy of the amplifier in precision applications.

8. Input Bias Current:

   • The input bias current is 50nA, which is relatively low, making the TL084IDR suitable for high-impedance sources.

9. Common Mode Rejection Ratio:

   • The CMRR is 80dB, indicating good rejection of common-mode signals, which is beneficial in noisy environments.

10. Power Consumption:

    • Each amplifier in the TL084IDR consumes approximately 1.5mW at ±15V supply, making it efficient for battery-powered devices.

11. Handling and Storage:

    • Handle the TL084IDR with care to avoid static damage. Store in a dry, cool place away from direct sunlight and corrosive substances.

12. Mounting:

    • Ensure proper heat dissipation by mounting the device on a suitable PCB with adequate copper area for thermal management.

13. Testing:

    • Before finalizing the design, test the circuit under various operating conditions to ensure stability and performance meet the requirements.

(For reference only)