Details

---

BUY AR8035-AL1B https://www.utsource.net/itm/p/12542990.html

Below is the parameter table and instructions for the AR8035-AL1B component.

Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Description
Supply Voltage	VCC	2.7	3.3	5.5	V	Operating supply voltage range
Operating Temperature	Ta	-40	-	85	°C	Ambient operating temperature range
Storage Temperature	Tstg	-55	-	125	°C	Storage temperature range
Output Current	Iout	-	100	200	mA	Maximum output current
Output Voltage Range	Vout	0.9	-	3.3	V	Adjustable output voltage range
Quiescent Current	IQ	-	2.5	5	μA	Quiescent current
Dropout Voltage	VDROPOUT	-	150	300	mV	Dropout voltage at maximum load current
Load Regulation	ΔVout/ΔIout	-	0.5	1	%	Change in output voltage with respect to change in output current
Line Regulation	ΔVout/ΔVin	-	0.01	0.05	%/V	Change in output voltage with respect to change in input voltage
Ripple Rejection	PSRR	-	60	70	dB	Power supply rejection ratio
Start-Up Time	tSTART	-	1.5	3	ms	Time required to reach stable output voltage from power-on
Shutdown Current	ISD	-	0.1	0.5	μA	Current consumption in shutdown mode
Enable Input Voltage	VEN	0.9	-	1.8	V	Minimum enable input voltage to activate the regulator
Enable Hysteresis	VHYST	-	100	200	mV	Hysteresis on enable input

Instructions

1. Power Supply Connection:

   • Connect the positive terminal of the power supply to the VCC pin.
   • Connect the negative terminal of the power supply to the GND pin.

2. Output Configuration:

   • Connect the output capacitor (typically 10 μF) between the Vout pin and GND.
   • Adjust the output voltage using the external resistor network connected to the FB (feedback) pin.

3. Enable Control:

   • To enable the regulator, apply a voltage greater than the enable threshold (VEN) to the EN pin.
   • To disable the regulator, apply a voltage less than the enable threshold to the EN pin.

4. Thermal Management:

   • Ensure adequate heat dissipation by providing a heat sink or thermal pad if operating at high output currents.
   • Keep the ambient temperature within the specified operating range to avoid thermal shutdown.

5. Capacitor Selection:

   • Use ceramic capacitors with low ESR for the input and output capacitors to ensure stability and minimize ripple.
   • For the input capacitor, a value of 1 μF to 10 μF is recommended.
   • For the output capacitor, a value of 10 μF to 100 μF is recommended.

6. PCB Layout:

   • Place the input and output capacitors as close as possible to the respective pins to minimize parasitic inductance.
   • Ensure a clean and short ground plane to reduce noise and improve performance.

7. Shutdown Mode:

   • To put the regulator into shutdown mode, pull the EN pin low. The quiescent current will drop to the shutdown current level (ISD).

8. Output Voltage Adjustment:

   • The output voltage can be adjusted using the formula: [ V_ = V_ left(1 + fracright) ] where ( V_ ) is the reference voltage (typically 0.9 V), ( R1 ) is the resistor connected between Vout and FB, and ( R2 ) is the resistor connected between FB and GND.

By following these parameters and instructions, you can effectively use the AR8035-AL1B in your design.

(For reference only)