Details

---

BUY TLE4252D https://www.utsource.net/itm/p/12543768.html

Below is the parameter table and instructions for the TLE4252D, a Hall sensor from Infineon Technologies.

TLE4252D Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Condition
Supply Voltage	VCC	4.5	5.0	5.5	V
Output High Level	VOH	-	4.7	-	V	IOL = 1 mA
Output Low Level	VOL	-	0.4	-	V	IOH = 1 mA
Output Leakage Current (High)	IOLH	-	10	-	μA	VOUT = 5V
Output Leakage Current (Low)	IOLL	-	-10	-	μA	VOUT = 0V
Magnetic Sensitivity	BOP	-	20	-	mT	Operate Point
Magnetic Sensitivity	BRP	-	-20	-	mT	Release Point
Operating Temperature Range	TOP	-40	-	125	°C
Storage Temperature Range	TSTG	-40	-	150	°C
Quiescent Current	IQ	-	3.5	-	mA	VCC = 5V
Response Time	tR	-	100	-	μs

Instructions for TLE4252D

1. Supply Voltage:

   • Ensure the supply voltage (V_CC) is within the range of 4.5V to 5.5V. The typical operating voltage is 5.0V.

2. Output Levels:

   • When the magnetic field exceeds the operate point (B_OP), the output will switch to a low level (V_OL ≈ 0.4V).
   • When the magnetic field falls below the release point (B_RP), the output will switch to a high level (V_OH ≈ 4.7V).

3. Magnetic Sensitivity:

   • The sensor will switch states when the magnetic field strength reaches the operate point (B_OP ≈ 20 mT) or the release point (B_RP ≈ -20 mT).

4. Temperature Range:

   • The device is designed to operate within a temperature range of -40°C to 125°C. Store the device within a temperature range of -40°C to 150°C.

5. Quiescent Current:

   • The quiescent current (I_Q) is typically 3.5 mA at a supply voltage of 5V.

6. Response Time:

   • The response time (t_R) is approximately 100 μs, which is the time it takes for the output to switch states after a change in the magnetic field.

7. Installation:

   • Mount the sensor in a location where it can detect the magnetic field without interference from other magnetic sources.
   • Ensure that the sensor is properly grounded to avoid noise and interference.

8. Handling:

   • Handle the device with care to avoid mechanical stress or damage.
   • Follow standard ESD (Electrostatic Discharge) precautions to prevent damage to the device.

9. Testing:

   • Test the device using a known magnetic field to verify its operation before integrating it into a larger system.

By following these parameters and instructions, you can ensure reliable operation of the TLE4252D Hall sensor in your application.

(For reference only)