Details

---

BUY AD7730LBRZ https://www.utsource.net/itm/p/12591197.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD		2.7		5.25	V
Reference Voltage	VREF	Internal	2.5			V
Input Voltage Range	VIN	Single-ended	0		VREF	V
Differential Input Voltage	VIN	Differential	-VREF/2		VREF/2	V
Conversion Rate	fCONV	Continuous	1.95	10	640	Hz
Output Data Rate	ODR		1.95	10	640	Hz
Power Consumption	IDD	Active, VDD = 5V		3.5		mA
Power Consumption	IDD	Standby, VDD = 5V		1		μA
Operating Temperature	Toper		-40		85	°C

Instructions for AD7730LBRZ

1. Power Supply Connection:

   • Connect the supply voltage (VDD) to a stable power source within the range of 2.7V to 5.25V.
   • Ensure proper decoupling capacitors are placed close to the VDD pin to minimize noise.

2. Reference Voltage Setup:

   • The device uses an internal reference voltage of 2.5V. For higher accuracy, an external reference can be used.
   • If using an external reference, connect it to the REF_IN pin.

3. Input Signal Configuration:

   • For single-ended input, connect the signal to one of the analog input channels and ground the other.
   • For differential input, connect the signal to both positive and negative input channels.

4. Conversion Rate Setting:

   • Set the desired conversion rate via the configuration registers. Rates can be set from 1.95Hz to 640Hz.
   • Higher rates reduce settling time but may increase noise.

5. Output Data Handling:

   • Read the output data through the SPI interface.
   • Ensure that the output data rate matches the conversion rate settings for accurate readings.

6. Power Management:

   • Use the standby mode to reduce power consumption when not actively converting.
   • Transition between active and standby modes via control register settings.

7. Temperature Considerations:

   • Ensure the operating temperature stays within -40°C to +85°C for reliable operation.
   • Avoid exposing the device to temperatures outside this range to prevent damage or performance degradation.

8. Initialization Sequence:

   • Upon power-up, initialize the device by configuring the necessary registers for your application requirements.
   • Verify the configuration settings before starting data acquisition.

For detailed information on register settings and specific configurations, refer to the AD7730LBRZ datasheet provided by Analog Devices.

(For reference only)