Details

---

BUY GM71C4260CJ60 https://www.utsource.net/itm/p/12591792.html

Parameter	Description	Value	Unit
Device Type	CMOS Static RAM	4M x 16	-
Supply Voltage (Vcc)	Operating voltage	2.5 to 3.6	V
Standby Current	Current consumption in standby mode	10	μA
Active Current	Current consumption in active mode	70	mA
Access Time	Time required for data access	55	ns
Package Type	Type of package	TSSOP-48	-
Operating Temperature	Temperature range for operation	-40 to +85	°C
Data Retention	Ability to retain data without power	10 years	-

Instructions for GM71C4260CJ60

1. Power Supply Connection:

   • Connect the Vcc pin to a stable power supply within the specified range (2.5V to 3.6V).
   • Ensure that the GND pin is properly grounded.

2. Signal Integrity:

   • Use decoupling capacitors close to the power pins to minimize noise and ensure stable operation.
   • Keep signal traces as short as possible to reduce interference and improve performance.

3. Address and Data Lines:

   • Connect address lines (A0-A19) to the appropriate control logic to select memory locations.
   • Data lines (D0-D15) should be connected to the data bus for read/write operations.

4. Control Signals:

   • Apply control signals such as Chip Select (CS), Write Enable (WE), Output Enable (OE), and Read/Write (R/W) according to the timing diagram provided in the datasheet.

5. Timing Considerations:

   • Ensure that all timing parameters, including setup and hold times for address and data, are adhered to for reliable operation.
   • Refer to the timing specifications section of the datasheet for detailed information.

6. Handling Precautions:

   • Handle the device with care to avoid electrostatic discharge (ESD) damage.
   • Store and transport the device in ESD protective packaging.

7. Testing and Validation:

   • After installation, perform testing to verify correct operation, including reading from and writing to various memory addresses.
   • Validate functionality under expected operating conditions, including temperature extremes if applicable.

(For reference only)