Details

---

BUY TMS320D788E001BRFP https://www.utsource.net/itm/p/12591909.html

Parameter	Description	Value
Part Number	Device Identifier	TMS320D788E001BRFP
Package Type	Encapsulation	BGA (Ball Grid Array)
Pin Count	Number of Pins	196
Operating Temperature Range	Range of temperatures over which the device can operate reliably	-40掳C to +85掳C
Supply Voltage (VCC)	Operating voltage range for the core supply	1.8V 卤 0.1V
I/O Supply Voltage (VIO)	Operating voltage range for I/O pins	1.8V to 3.3V
Clock Frequency	Maximum clock frequency supported by the device	300 MHz
Core Architecture	Processor architecture	C674x DSP Core
Memory	On-chip memory configuration	1 MB L1P Cache, 1 MB L1D Cache, 16 MB L2 Memory
DMA Channels	Number of Direct Memory Access channels	16
ADC Channels	Number of Analog-to-Digital Converter channels	2
DAC Channels	Number of Digital-to-Analog Converter channels	2
GPIO Pins	Number of General Purpose Input/Output pins	64
UART Interfaces	Number of Universal Asynchronous Receiver-Transmitter interfaces	2
SPI Interfaces	Number of Serial Peripheral Interface buses	2
I2C Interfaces	Number of Inter-Integrated Circuit buses	2
CAN Interfaces	Number of Controller Area Network interfaces	2
Ethernet MAC	Ethernet Media Access Control support	Yes
USB Interfaces	Number of Universal Serial Bus interfaces	1 (USB 2.0 Full Speed)
PWM Outputs	Number of Pulse Width Modulation outputs	8
Watchdog Timer	On-chip watchdog timer	Yes
Power Consumption	Typical power consumption at maximum clock frequency	1.5W
ESD Protection	Electrostatic Discharge protection level	HBM: 2kV, MM: 200V
RoHS Compliance	Compliance with Restriction of Hazardous Substances Directive	Yes

Instructions for Use:

1. Power Supply:

   • Ensure that the VCC (core supply) is set to 1.8V 卤 0.1V.
   • The I/O supply (VIO) should be set between 1.8V and 3.3V, depending on the application requirements.

2. Clock Configuration:

   • The device supports a maximum clock frequency of 300 MHz. Ensure that the clock source is stable and within the specified range.

3. Memory Initialization:

   • Initialize the L1P and L1D caches and L2 memory as per the application requirements. Refer to the device datasheet for specific initialization sequences.

4. Peripheral Configuration:

   • Configure the UART, SPI, I2C, CAN, and USB interfaces according to the communication protocols and speeds required by the application.
   • Set up the ADC and DAC channels for analog signal processing.
   • Configure the GPIO pins for input or output based on the application needs.

5. DMA and PWM Setup:

   • Use the DMA channels to transfer data efficiently between memory and peripherals.
   • Configure the PWM outputs for controlling motors, LEDs, or other devices requiring pulse width modulation.

6. Watchdog Timer:

   • Enable and configure the watchdog timer to reset the system if it becomes unresponsive.

7. Thermal Management:

   • Ensure adequate cooling for the device, especially when operating at high clock frequencies and power levels. Use heatsinks or thermal vias as necessary.

8. ESD Handling:

   • Handle the device with care to avoid ESD damage. Use proper ESD protection equipment and follow recommended handling procedures.

9. RoHS Compliance:

   • Verify that the device complies with RoHS regulations if required for your application.

For detailed information and specific programming guidelines, refer to the TMS320D788E001BRFP datasheet and user manual.

(For reference only)