Details

---

BUY LNK305PN https://www.utsource.net/itm/p/12592137.html

Parameter	Symbol	Min	Typical	Max	Unit	Notes
Input Voltage	VIN	70	-	375	VDC	Operating input voltage range
Output Power	POUT	-	5	8	W	Maximum continuous output power
Quiescent Current	IQ	-	1.2	-	mA	At no load, typical value
Start-Up Current	ISTART	-	10	-	渭A	Typical start-up current
Minimum Load Current	ILOAD(MIN)	-	0.1	-	mA	Minimum load current for stable operation
Output Voltage Range	VOUT	-	5	15	VDC	Adjustable output voltage range
Output Ripple	VPP	-	50	100	mVpp	Peak-to-peak ripple at full load
Efficiency	畏	-	75	85	%	Typical efficiency at nominal conditions
Operating Temperature	TOPR	-40	-	85	掳C	Operating temperature range
Storage Temperature	TSTG	-65	-	150	掳C	Storage temperature range
Thermal Shutdown	TSD	-	160	-	掳C	Typical thermal shutdown temperature
Protection Features	-	-	-	-	-	Overvoltage, overcurrent, short-circuit, thermal

Instructions for Using the LNK305PN

1. Input Connection:

   • Connect the positive terminal of the input voltage to the DRAIN pin.
   • Connect the negative terminal of the input voltage to the SOURCE pin.

2. Output Configuration:

   • Connect the output capacitor (COUT) between the SOURCE pin and the output load.
   • Use a feedback resistor network (R1 and R2) to set the desired output voltage. The formula for output voltage is: [ V_ = V_ left(1 + fracright) ] where ( V_ ) is typically 2.5V.

3. Feedback Loop:

   • Connect the feedback resistor network to the FB pin.
   • Ensure the feedback loop is stable by using appropriate compensation components if necessary.

4. Thermal Management:

   • Ensure adequate heat dissipation by mounting the LNK305PN on a heatsink or a PCB with good thermal conductivity.
   • Monitor the operating temperature to avoid exceeding the maximum operating temperature.

5. Protection Circuits:

   • The LNK305PN includes built-in protection features such as overvoltage, overcurrent, short-circuit, and thermal shutdown.
   • Ensure that the input and output circuits are designed to handle these protections to prevent damage.

6. Testing and Validation:

   • Test the circuit under various load conditions to ensure stability and performance.
   • Verify the output voltage and ripple meet the design requirements.

7. Storage and Handling:

   • Store the LNK305PN in a dry, cool place within the specified storage temperature range.
   • Handle the device with care to avoid static discharge and physical damage.

By following these instructions, you can ensure reliable and efficient operation of the LNK305PN in your application.

(For reference only)