Details

---

BUY LF353MX/NOPB https://www.utsource.net/itm/p/12593537.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VCC	-	4.5	-	36	V
Supply Current	ICC	VCC = 12V, no load	-	0.7	-	mA
Input Offset Voltage	VIO	VCC = ±15V	2	5	10	mV
Input Bias Current	IB	VCC = ±15V	20	80	150	nA
Input Offset Current	IOS	VCC = ±15V	2	10	50	nA
Common-Mode Rejection Ratio	CMRR	VCC = ±15V	80	-	90	dB
Power-Supply Rejection Ratio	PSRR	VCC = ±15V	90	-	100	dB
Slew Rate	SR	VCC = ±15V	13	-	-	V/μs
Output Voltage Swing	VOUT	VCC = ±15V, RL = 2kΩ	-13	-	13	V
Bandwidth (Small Signal)	f-3dB	VCC = ±15V, G = +1	3	-	-	MHz
Equivalent Input Noise Voltage	en	VCC = ±15V, f = 1kHz	20	-	-	nV/√Hz

Instructions for Using LF353MX/NOPB

1. Power Supply:

   • The LF353MX/NOPB can operate with a single supply voltage ranging from 4.5V to 36V or dual supplies up to ±18V.
   • Ensure that the power supply is stable and free from noise to avoid performance degradation.

2. Input Signals:

   • The input signals should be within the common-mode input voltage range, which is typically from 3V below the negative supply to 3V below the positive supply.
   • Use input biasing resistors if necessary to ensure the inputs are within the valid range.

3. Output Configuration:

   • The output voltage swing is typically within 2V of each supply rail. For example, with a ±15V supply, the output can swing from -13V to +13V.
   • Use appropriate load resistors to match the output impedance and ensure proper signal transfer.

4. Slew Rate:

   • The slew rate is 13 V/μs, which limits the maximum rate of change of the output voltage. This is important for high-frequency applications.

5. Noise Considerations:

   • The equivalent input noise voltage is 20 nV/√Hz at 1 kHz. Use shielding and proper grounding techniques to minimize external noise interference.

6. Stability:

   • The LF353MX/NOPB is unity-gain stable. However, for stability at higher gains, use compensation techniques such as adding a small capacitor in parallel with the feedback resistor.

7. Temperature Range:

   • The operating temperature range is typically -40°C to +125°C. Ensure that the device is used within this range to maintain performance specifications.

8. Storage and Handling:

   • Store the device in a dry, cool place to prevent moisture damage.
   • Handle the device with care to avoid static discharge, which can damage the internal components.

By following these instructions, you can ensure optimal performance and reliability of the LF353MX/NOPB operational amplifier in your circuits.

(For reference only)