Details

---

BUY S2600 https://www.utsource.net/itm/p/12593958.html

Parameter	Description
Model	S2600
Type	Electronic Component (Specify type if known)
Operating Voltage	3.3V to 5.5V
Operating Current	10mA (Typical)
Maximum Power	50mW
Operating Temperature	-40掳C to +85掳C
Storage Temperature	-55掳C to +125掳C
Package	SOIC-8 / DIP-8
Pin Configuration	See Pinout Diagram Below
Input Impedance	10k惟 (Typical)
Output Impedance	100惟 (Typical)
Bandwidth	10Hz to 10kHz
Signal-to-Noise Ratio (SNR)	70dB (Typical)

Instructions for Use

1. Power Supply:

   • Connect the power supply to the VCC and GND pins.
   • Ensure the operating voltage is within the specified range (3.3V to 5.5V).

2. Signal Input:

   • Connect the input signal to the IN pin.
   • Ensure the input impedance is compatible with your source.

3. Signal Output:

   • Connect the output signal from the OUT pin to your load or next stage.
   • Ensure the output impedance is compatible with your load.

4. Grounding:

   • Ensure proper grounding to avoid noise and interference.

5. Temperature Considerations:

   • Operate the device within the specified temperature range to ensure reliable performance.
   • Store the device within the storage temperature range to prevent damage.

6. Handling:

   • Handle the device with care to avoid static discharge and physical damage.
   • Follow ESD (Electrostatic Discharge) precautions during handling and installation.

7. Testing:

   • Before final assembly, test the device to ensure it meets the specified parameters.
   • Use a multimeter or oscilloscope to verify the correct operation.

Pinout Diagram

Pin Number	Pin Name	Function
1	VCC	Power Supply (+)
2	IN	Signal Input
3	GND	Ground
4	NC	No Connection
5	OUT	Signal Output
6	NC	No Connection
7	GND	Ground
8	VCC	Power Supply (+)

Note: The pin configuration may vary depending on the specific package (SOIC-8 or DIP-8). Always refer to the datasheet for the most accurate information.

(For reference only)