Details

---

BUY JW2SN-DC24V https://www.utsource.net/itm/p/12594856.html

Below is the parameter table and instructions for the JW2SN-DC24V.

Parameter Table

Parameter	Value
Model Number	JW2SN-DC24V
Input Voltage	DC 24V
Operating Current	100mA (Max)
Output Type	Normally Open (NO)
Contact Rating	5A @ 24V DC
Switching Capacity	120W (Max)
Response Time	< 10ms
Operating Temperature	-20掳C to +70掳C
Storage Temperature	-40掳C to +85掳C
Humidity Range	5% to 95% RH (Non-condensing)
Protection	Reverse Polarity Protection
Mounting	Panel Mount
Dimensions	30mm x 20mm x 15mm
Weight	30g
Certifications	CE, RoHS

Instructions

1. Installation:

   • Ensure that the input voltage is DC 24V.
   • Mount the JW2SN-DC24V on a suitable panel using the provided mounting screws.
   • Connect the input wires to the terminal block labeled "IN" and the output wires to the terminal block labeled "OUT."

2. Wiring:

   • Input Wiring:
     • Connect the positive terminal of the power supply to the "+" terminal.
     • Connect the negative terminal of the power supply to the "-" terminal.
   • Output Wiring:
     • Connect the load to the "COM" and "NO" terminals.
     • The "COM" terminal is the common terminal.
     • The "NO" terminal is the normally open terminal.

3. Operation:

   • When the sensor detects the target, the relay will switch from the normally open (NO) state to the closed state, allowing current to flow through the load.
   • The response time is less than 10ms, ensuring quick and reliable operation.

4. Maintenance:

   • Regularly inspect the connections for any signs of wear or damage.
   • Ensure that the operating environment is within the specified temperature and humidity ranges.
   • Do not exceed the maximum current rating of 5A at 24V DC to avoid damage to the relay.

5. Troubleshooting:

   • No Output:
     • Check the input voltage and ensure it is DC 24V.
     • Verify that the connections are secure and not loose.
   • Intermittent Operation:
     • Check for any interference or noise in the power supply.
     • Ensure that the load is within the switching capacity of the relay.

6. Safety Precautions:

   • Always disconnect the power supply before installing or servicing the relay.
   • Use appropriate personal protective equipment (PPE) when handling electrical components.
   • Follow all local electrical codes and regulations.

By following these instructions, you can ensure the safe and efficient operation of the JW2SN-DC24V relay.

(For reference only)