Details

---

BUY TLC1543QDW https://www.utsource.net/itm/p/12595075.html

Below is the parameter table and instructions for the TLC1543QDW, a 12-bit analog-to-digital converter (ADC) from Texas Instruments.

TLC1543QDW Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit
Supply Voltage	VCC	4.75	5.0	5.25	V
Analog Input Voltage Range	VIN	0	-	VCC	V
Conversion Time	tCONV	-	20	-	渭s
Sampling Rate	fS	-	50	-	kSPS
Resolution	-	-	12	-	bits
Differential Nonlinearity (DNL)	DNL	-1	0	+1	LSB
Integral Nonlinearity (INL)	INL	-1	0	+1	LSB
Offset Error	VOFFSET	-	0	5	mV
Full-Scale Error	VFSE	-	0	5	mV
Power Consumption	ICC	-	2.5	-	mA
Operating Temperature Range	TOP	-40	-	85	掳C
Storage Temperature Range	TSTG	-65	-	150	掳C

Instructions for Using the TLC1543QDW

1. Power Supply:

   • Connect the V_CC pin to a 5V power supply.
   • Connect the GND pin to ground.

2. Analog Input:

   • Connect the analog signal to be converted to the AIN pin.
   • Ensure the input voltage is within the range of 0V to V_CC.

3. Digital Interface:

   • The TLC1543QDW uses a serial interface for communication.
   • Connect the SCLK (Serial Clock), SDI (Serial Data In), and SDO (Serial Data Out) pins to the corresponding pins on your microcontroller or digital system.

4. Conversion Start:

   • To start a conversion, send a start conversion command by toggling the CS (Chip Select) pin low.
   • After the CS pin is low, the ADC will begin the conversion process.

5. Reading the Result:

   • After the conversion time (typically 20 渭s), the result can be read from the SDO pin.
   • The data is read out as a 12-bit binary code, with the most significant bit (MSB) first.

6. End of Conversion:

   • Once the data has been read, set the CS pin high to end the conversion cycle.

7. Timing Diagram:

   • Refer to the timing diagram in the datasheet for detailed timing requirements, including setup and hold times for the SCLK and data lines.

8. Error Handling:

   • Monitor the DNL and INL specifications to ensure accurate conversions.
   • Check for offset and full-scale errors to calibrate the ADC if necessary.

9. Power Management:

   • To reduce power consumption, consider using the sleep mode if available in your application.

10. Temperature Considerations:

    • Ensure that the operating temperature is within the specified range to maintain accuracy and reliability.

By following these instructions, you can effectively use the TLC1543QDW in your analog-to-digital conversion applications.

(For reference only)