Details

---

BUY EPM7064SLC44-10N https://www.utsource.net/itm/p/12596416.html

Parameter	Description	Value
Device Type	Logic Family	MAX 7000S
Package	Package Type	LCC (Leadless Chip Carrier)
Pin Count	Number of Pins	44
Operating Temperature Range	Temperature Range	-40°C to +85°C
Supply Voltage (Vcc)	Voltage Range	3.3V ± 0.3V
Configuration Memory	Non-Volatile Memory	22,118 bits
Logic Cells	Number of Logic Cells	64
Macrocells	Number of Macrocells	64
I/O Pins	Number of I/O Pins	32
Maximum Frequency	Clock Frequency	100 MHz
Power Consumption	Typical Power Consumption	100 mW (typical)
Speed Grade	Speed Grade	-10
Configuration Method	Configuration Mode	AS (Active Serial), PS (Passive Serial), ISC (In-System Configuration)
JTAG Support	JTAG Boundary Scan	Yes
ESD Protection	Electrostatic Discharge Protection	HBM: 2000V, MM: 200V

Instructions for Using EPM7064SLC44-10N

1. Power Supply:

   • Ensure the supply voltage (Vcc) is within the specified range of 3.3V ± 0.3V.
   • Connect the Vcc pin to a stable 3.3V power source and the GND pins to ground.

2. Configuration:

   • Use one of the supported configuration methods: Active Serial (AS), Passive Serial (PS), or In-System Configuration (ISC).
   • For AS and PS modes, connect the configuration pins (DCLK, DIN, DOUT, and nCONFIG) to the appropriate signals.
   • For ISC mode, ensure the device is connected to a programming interface that supports in-system configuration.

3. JTAG Boundary Scan:

   • Connect the JTAG pins (TCK, TMS, TDI, TDO) to the JTAG interface for boundary scan testing and debugging.

4. I/O Pins:

   • Configure the I/O pins as inputs or outputs based on your application requirements.
   • Ensure that the I/O voltages do not exceed the Vcc level.

5. Clock Input:

   • Connect a clock signal to the appropriate clock input pin (e.g., GCLK0) to drive the logic cells.
   • Ensure the clock frequency does not exceed the maximum frequency of 100 MHz.

6. ESD Protection:

   • Handle the device with care to avoid electrostatic discharge (ESD).
   • Follow ESD handling procedures and use appropriate grounding techniques.

7. Operating Temperature:

   • Operate the device within the temperature range of -40°C to +85°C to ensure reliable performance.

8. Power-Up Sequence:

   • Apply power to the Vcc pin before applying any signals to the I/O pins.
   • Allow sufficient time for the device to initialize after power-up.

9. Decoupling Capacitors:

   • Place decoupling capacitors close to the Vcc and GND pins to minimize noise and ensure stable operation.

10. Programming and Testing:

    • Use a compatible programmer and software to program the device with your design.
    • Verify the functionality of the programmed device using test vectors and boundary scan techniques.

For detailed specifications and additional information, refer to the datasheet provided by the manufacturer.

(For reference only)