Details

---

BUY 86C765 https://www.utsource.net/itm/p/12596434.html

Parameter	Description	Value
Device Type	High-performance microcontroller	80C188-based
Package	Plastic Quad Flat Package (PQFP)	80-pin
Operating Voltage	Supply voltage range	4.75V to 5.25V
Clock Frequency	Maximum clock frequency	20 MHz
Flash Memory	On-chip program memory	64 KB
RAM	On-chip data memory	2 KB
I/O Ports	Number of I/O lines	32
Serial Communication	UART, SPI, I2C interfaces	Supported
Timers/Counters	Number of timers/counters	3
Watchdog Timer	On-chip watchdog timer	Yes
Power Management	Low power modes	Sleep, Idle
Temperature Range	Operating temperature range	-40掳C to +85掳C
Programming Model	Instruction set architecture	80C188
Programming Interface	In-circuit serial programming (ICSP)	Supported

Instructions for Use

1. Power Supply:

   • Connect the VCC pin to a stable 5V power supply.
   • Connect the GND pin to ground.

2. Clock Configuration:

   • Connect an external crystal or oscillator to the XTAL1 and XTAL2 pins if using an external clock source.
   • Alternatively, configure the internal oscillator if applicable.

3. Reset:

   • Apply a high signal to the RESET pin for at least two clock cycles to initialize the microcontroller.

4. Programming:

   • Use an ICSP programmer to load the firmware into the flash memory.
   • Ensure the programming voltage (VPP) is applied correctly during programming.

5. I/O Configuration:

   • Configure the I/O ports using the appropriate registers (e.g., P0DIR, P1DIR).
   • Set the direction of each port (input or output).

6. Interrupts:

   • Enable interrupts by setting the appropriate bits in the interrupt control registers.
   • Write interrupt service routines (ISRs) to handle specific events.

7. Low Power Modes:

   • Enter sleep mode by writing to the power control register.
   • Use the watchdog timer to ensure the microcontroller wakes up periodically.

8. Communication Interfaces:

   • Initialize UART, SPI, or I2C interfaces by configuring the respective control registers.
   • Use the provided library functions or write custom code to manage communication.

9. Timers/Counters:

   • Set up the timers/counters by configuring the prescaler, mode, and interrupt enable bits.
   • Use the timers for timing events, PWM generation, or other time-related tasks.

10. Watchdog Timer:

    • Enable the watchdog timer by writing to the watchdog control register.
    • Reset the watchdog timer periodically to prevent a system reset.

11. Debugging:

    • Use an in-circuit debugger to monitor and control the microcontroller during development.
    • Utilize breakpoints and watchpoints to debug the code.

12. Storage and Handling:

    • Store the device in a static-protected environment.
    • Handle with care to avoid damage from electrostatic discharge (ESD).

For detailed information, refer to the datasheet and application notes provided by the manufacturer.

(For reference only)