Details

---

BUY M57924L https://www.utsource.net/itm/p/12597169.html

Below is the parameter table and instructions for the M57924L:

Parameter Table

Parameter	Symbol	Min	Typ	Max	Unit	Conditions
Supply Voltage	Vcc	4.5	5.0	5.5	V
Operating Temperature	Ta	-40		85	掳C
Storage Temperature	Tstg	-65		150	掳C
Input Current (High Level)	IIH	0.1	0.4	1.0	mA	Vih = 4.5V to 5.5V
Input Current (Low Level)	IIL	-1.0	-0.4	-0.1	mA	Vil = 0V to 0.8V
Output Current (High Level)	IOH	-0.4	-2.0	-4.0	mA	Vo = 2.4V, Vcc = 5V
Output Current (Low Level)	IOL	4.0	8.0	16.0	mA	Vo = 0.4V, Vcc = 5V
Propagation Delay Time	tpd	15	25	35	ns	Vcc = 5V, Ta = 25掳C
Power Dissipation	PD		150		mW	Vcc = 5V, Ta = 25掳C

Instructions

1. Supply Voltage (Vcc):

   • The device operates within a supply voltage range of 4.5V to 5.5V. Ensure that the power supply is stable and within this range to avoid damage or erratic behavior.

2. Operating Temperature (Ta):

   • The device is designed to operate in environments with temperatures ranging from -40掳C to 85掳C. Ensure that the device is not exposed to temperatures outside this range to prevent performance degradation or failure.

3. Storage Temperature (Tstg):

   • When the device is not in use, store it in an environment with temperatures between -65掳C and 150掳C to ensure long-term reliability.

4. Input Current:

   • The input current for high-level signals (IIH) should be between 0.1mA and 1.0mA when the input voltage (Vih) is between 4.5V and 5.5V.
   • The input current for low-level signals (IIL) should be between -1.0mA and -0.1mA when the input voltage (Vil) is between 0V and 0.8V.

5. Output Current:

   • The output current for high-level signals (IOH) should be between -0.4mA and -4.0mA when the output voltage (Vo) is 2.4V and the supply voltage (Vcc) is 5V.
   • The output current for low-level signals (IOL) should be between 4.0mA and 16.0mA when the output voltage (Vo) is 0.4V and the supply voltage (Vcc) is 5V.

6. Propagation Delay Time (tpd):

   • The propagation delay time is the time it takes for a change in the input signal to result in a corresponding change in the output signal. It ranges from 15ns to 35ns at a supply voltage of 5V and an ambient temperature of 25掳C.

7. Power Dissipation (PD):

   • The maximum power dissipation of the device is 150mW at a supply voltage of 5V and an ambient temperature of 25掳C. Ensure that the device is not subjected to excessive power dissipation to avoid overheating and potential damage.

Additional Notes:

• Always refer to the datasheet for the most accurate and detailed information.
• Proper decoupling capacitors should be used near the power supply pins to ensure stable operation.
• Follow good PCB layout practices to minimize noise and interference.

If you have any specific questions or need further details, feel free to ask!

(For reference only)