Details

---

BUY A20B-2902-0120/01 https://www.utsource.net/itm/p/12597202.html

Parameter	Value
Model Number	A20B-2902-0120/01
Type	Incremental Encoder
Resolution	1200 ppr (Pulses per Revolution)
Output Type	Push-Pull (HTL)
Supply Voltage	5 VDC to 24 VDC
Current Consumption	≤ 50 mA
Operating Temperature	-25°C to +85°C
Shaft Diameter	6 mm
Shaft Length	12 mm
Shaft End Play	< 0.1 mm
Radial Play	< 0.1 mm
Electrical Life	> 10 million cycles
Mechanical Life	> 50 million cycles
Protection Class	IP64 (Shaft Sealed)
Weight	≈ 30 g

Instructions for Use:

1. Installation:

   • Ensure the encoder shaft is aligned with the motor or device it will be attached to.
   • Secure the encoder to the mounting surface using the provided screws or mounting method.

2. Wiring:

   • Connect the supply voltage (Vcc) to the positive terminal of the encoder.
   • Connect the ground (GND) to the negative terminal of the encoder.
   • Connect the output signals (A, B, Z) to the appropriate input pins on your control system.

3. Operation:

   • Power on the encoder by applying the specified supply voltage.
   • Rotate the shaft to generate pulses. The A and B channels will provide quadrature signals, while the Z channel provides a single pulse per revolution for reference.

4. Maintenance:

   • Regularly inspect the encoder for any signs of wear or damage.
   • Keep the encoder clean and free from debris to ensure optimal performance.

5. Storage:

   • Store the encoder in a dry, cool place away from direct sunlight and extreme temperatures.

6. Troubleshooting:

   • If the encoder does not produce pulses, check the power supply and connections.
   • If the signal is noisy, ensure proper shielding and grounding of the cables.

(For reference only)