Details

---

BUY CD4066BE https://www.utsource.net/itm/p/12597231.html

Parameter	Symbol	Conditions	Min	Typ	Max	Unit
Supply Voltage	VDD	-	3	15	-	V
Supply Current (Quiescent)	IDD	VDD = 15V, all switches off	-	1	-	渭A
Input High Voltage	VIH	-	2.0	3.5	VDD	V
Input Low Voltage	VIL	-	0	1.5	-	V
Output High Voltage	VOH	IO = -1mA	-	VDD - 0.1	VDD - 0.5	V
Output Low Voltage	VOL	IO = 1mA	0.1	0.5	-	V
On-State Resistance	RON	VDD = 15V, VIN = VDD/2, IO = 卤10mA	-	125	250	惟
Off-State Leakage Current	IOFF	VDD = 15V, VIN = 0V or VDD	-	-	1	nA
Switching Time (Typical)	tpd	VDD = 15V, VIN = 0V to VDD	-	15	-	ns

Instructions for Using CD4066BE

1. Supply Voltage:

   • Ensure the supply voltage (V_DD) is within the range of 3V to 15V.
   • Connect V_DD to the positive supply and GND to the ground.

2. Input Levels:

   • For a high input (V_IH), the voltage should be at least 2.0V and can go up to V_DD.
   • For a low input (V_IL), the voltage should be between 0V and 1.5V.

3. Output Levels:

   • When a switch is on, the output high voltage (V_OH) will be close to V_DD minus a small drop (0.1V to 0.5V).
   • When a switch is off, the output low voltage (V_OL) will be close to 0V with a small rise (0.1V to 0.5V).

4. On-State Resistance:

   • The resistance when the switch is on (R_ON) is typically around 125惟 but can vary between 125惟 and 250惟 depending on conditions.

5. Off-State Leakage Current:

   • The leakage current when the switch is off (I_OFF) is very low, typically less than 1nA.

6. Switching Time:

   • The typical propagation delay time (t_pd) is 15ns, which is the time it takes for the output to change state after the input changes.

7. Handling and Storage:

   • Handle the device with care to avoid damage from static electricity.
   • Store in a dry environment to prevent moisture damage.

8. Layout Considerations:

   • Keep signal paths short to minimize noise and interference.
   • Use decoupling capacitors (e.g., 0.1渭F) close to the power pins to filter out noise.

9. Testing:

   • Test the device under typical operating conditions to ensure it meets the specified parameters.
   • Verify the switching behavior and leakage currents to ensure proper functionality.

By following these guidelines, you can effectively use the CD4066BE in your circuits.

(For reference only)