Details

---

BUY ATMEGA88PA-PU https://www.utsource.net/itm/p/12597520.html

Parameter	Description	Value
Package Type	The type of package the microcontroller comes in	PDIP-28
Operating Voltage (Vcc)	Range of supply voltage for operation	1.8 - 5.5 V
Flash Memory	Size of on-chip flash memory	8 KB
SRAM	Size of on-chip SRAM	1 KB
EEPROM	Size of on-chip EEPROM	512 Bytes
Clock Speed	Maximum clock speed	20 MHz
I/O Pins	Number of input/output pins	23
ADC Channels	Number of analog-to-digital converter channels	8
PWM Channels	Number of pulse-width modulation channels	6
Timers/Counters	Number and type of timers	2 x 8-bit, 1 x 16-bit
Watchdog Timer	Availability of watchdog timer	Yes
UART	Number of universal asynchronous receiver/transmitter interfaces	1
SPI	Availability of serial peripheral interface	Yes
TWI	Availability of two-wire interface (I2C)	Yes
Temperature Range	Operating temperature range	-40掳C to +85掳C
Power Consumption	Typical power consumption at 3.0V, 1 MHz	0.7 mA
Programming Interface	Interface used for programming the device	ISP, TPI

Instructions for ATMEGA88PA-PU:

1. Power Supply Setup:

   • Connect Vcc to a stable power supply between 1.8V and 5.5V.
   • Ensure proper decoupling capacitors are placed near the power pins.

2. Clock Configuration:

   • Select an appropriate clock source (internal RC oscillator, external crystal/resonator, or external clock).
   • Configure the CKSEL fuses as needed for the selected clock source.

3. Programming:

   • Use In-System Programming (ISP) or Tiny Programming Interface (TPI) for loading programs into the flash memory.
   • Ensure the correct programmer settings are selected in your development environment.

4. Pin Configuration:

   • Configure I/O pins as inputs or outputs using DDRx registers.
   • Set initial states of output pins using PORTx registers.

5. Peripheral Setup:

   • Initialize peripherals like ADC, PWM, UART, SPI, and TWI according to application needs.
   • Refer to the datasheet for specific configuration details and register settings.

6. Interrupt Handling:

   • Enable interrupts globally using the I-bit in SREG.
   • Set up individual interrupt sources by configuring corresponding control registers.

7. Debugging:

   • Utilize built-in debugWIRE interface for debugging purposes.
   • Make sure to disable debugWIRE if not needed to avoid conflicts with other functions.

8. Power Management:

   • Implement sleep modes to reduce power consumption when the device is idle.
   • Use watchdog timer to ensure reliable operation during sleep modes.

For detailed information and advanced configurations, refer to the official ATMEGA88PA-PU datasheet.

(For reference only)