Details

---

BUY SJ-S-112DMH https://www.utsource.net/itm/p/12598125.html

Parameter	Description	Value
Part Number	Unique identifier for the component	SJ-S-112DMH
Type	Type of component	MOSFET
Package	Physical package type	TO-252 (DPAK)
Drain-Source Voltage	Maximum voltage between drain and source	100V
Gate-Source Voltage	Maximum voltage between gate and source	卤20V
Continuous Drain Current	Maximum continuous current through the drain	6.5A
Peak Pulse Drain Current	Maximum pulse current through the drain (t<10ms)	38A
Rds(on) at Vgs=10V	On-state resistance at gate-source voltage of 10V	0.045惟
Power Dissipation	Maximum power dissipation	3.5W
Junction Temperature	Maximum operating temperature of the junction	-55掳C to +175掳C
Storage Temperature	Temperature range for storage	-55掳C to +150掳C
Total Gate Charge	Total charge required to switch the device	39nC
Input Capacitance	Capacitance between gate and source at Vds=0V, Vgs=0V	1100pF
Output Capacitance	Capacitance between drain and source at Vgs=0V	220pF
Reverse Transfer Capacitance	Capacitance between drain and gate at Vds=0V, Vgs=0V	40pF

Instructions for Use:

1. Handling Precautions:

   • Handle with care to avoid damage to the leads and body.
   • Use proper ESD (Electrostatic Discharge) protection when handling the device.

2. Mounting:

   • Ensure that the mounting surface is clean and free from contaminants.
   • Apply thermal paste or a thermal pad to improve heat dissipation if necessary.
   • Secure the component using appropriate mounting hardware to ensure good thermal contact.

3. Soldering:

   • Use a soldering iron with a temperature setting suitable for the TO-252 package.
   • Solder the leads within the recommended time and temperature limits to avoid thermal stress.

4. Operating Conditions:

   • Do not exceed the maximum ratings listed in the parameter table.
   • Ensure adequate cooling to keep the junction temperature within the specified range.
   • Use appropriate gate drive circuits to minimize switching losses and ensure reliable operation.

5. Testing:

   • Test the device under controlled conditions to verify its performance.
   • Use a multimeter or other test equipment to check for continuity and resistance values as needed.

6. Storage:

   • Store the device in a dry, cool place away from direct sunlight.
   • Keep the device in its original packaging until ready for use to protect it from static and physical damage.

(For reference only)